Behringer Inuke 1000DSP, 3000DSP faulty, Fixed, Ring of death

  Рет қаралды 917

Wayne's Share the Knowledge

Wayne's Share the Knowledge

Күн бұрын

Behringer Inuke 1000DSP faulty, the circuit diagram is the same as the 3000 but this PCB has a few extra components.
red RING of DEATH
This video is for entertainment purposes only
Copying any of my modifications will void your warranty
and could lead to electrocution.
DO AT YOUR OWN RISK
Loud ticking sound on Channel A, sounded like the Switch mode power supply not starting up?
Circuit diagram and component datasheets available on a internet search
faults
Output Mosfets (IRFS23N15DPbF) T10, T11, T12 and T13, read as open circuit, little unusual as most Mofet's go short.
Replaced with IRFS4227PbF
C69 - 1uf 250v cap had gone all but short 2ohm
IC15 (IRS20955(S)PbF) faulty
Replaced IC15 and IC16 with IRS20957S
Test equipment
Standard Multi meter with diode check
Multi-function tester T7

Пікірлер: 5
@AnnaVannieuwenhuyse
@AnnaVannieuwenhuyse 2 ай бұрын
The MOSFET parts are discontinued, but not a big deal. The NU1000 series use surface mounted parts, so they're different packages and those weren't available for the 4227's. You can replace them with the parts mentioned in the NU3K manual if they'll fit, that's fine. They'll work just fine, the driver stages will drive them just fine.
@cambridgemart2075
@cambridgemart2075 7 ай бұрын
That's a weird failure for a polyester film cap at relatively low voltage. As you say, MOSFETs normally fail short, so good catch! For the drivers to fail is odd though as they are normally killed by a shorted MOSFET, although they are extremely sensitive to a difference in the voltage between the input and drive side ground voltages.
@AnnaVannieuwenhuyse
@AnnaVannieuwenhuyse 2 ай бұрын
To me, this indicates someone may have tried to parallel the channels or backfed it from another amplifier, which by itself wouldn't be a problem if there's no DC offset; however, the iNuke series has about 1.2mV of DC offset -- completely acceptable, but not safe for putting itself into parallel and accidentally reversing polarity on one.
@Ardas1969
@Ardas1969 2 ай бұрын
Hi friend. Do you have a circuit diagram of the board?
@waynephillips1848
@waynephillips1848 2 ай бұрын
I found it by searching google for Behringer iNuke NU1000 Schematics.pdf
Behringer NX6000D Power Amplifier Repair (With Audio Tutorial)
27:01
Audio Amplifier Servicing
Рет қаралды 7 М.
Audiophile Power Regenerator Repair (PS Audio Power Plant 300)
28:24
小丑教训坏蛋 #小丑 #天使 #shorts
00:49
好人小丑
Рет қаралды 54 МЛН
Сестра обхитрила!
00:17
Victoria Portfolio
Рет қаралды 958 М.
Sony CDP-M26  NO-DISC Error,  laser diode replacement  KSS-150A and fault find.
21:24
Wayne's Share the Knowledge
Рет қаралды 749
Behringer iNuke NU1000 Amp Dyno Test
9:24
Williston Audio Labs
Рет қаралды 91 М.
Lets Fix a Ford PCM
25:53
jeffescortlx
Рет қаралды 90 М.
Samsung 860 Evo SSD Repair- Data Recovery Lab said it wasn't possible.
14:44
Idle Hands & A Tormek!
29:57
This Old Tony
Рет қаралды 315 М.
Class A amplifier kit - fixing the distortion problem
14:56
JohnAudioTech
Рет қаралды 113 М.
HP 8903 Faulty, A2 card and no -15v rail, Error 18 or 19 Diagnostic indicators
9:08
Wayne's Share the Knowledge
Рет қаралды 124
PEAVEY 4000W Amp Repair (CS4080HZ)
45:42
Mend It Mark
Рет қаралды 384 М.
The 5 kilowatt Crown
46:21
Mend It Mark
Рет қаралды 598 М.
Behringer Inuke 12000
5:58
maykell pinder
Рет қаралды 3,6 М.
小丑教训坏蛋 #小丑 #天使 #shorts
00:49
好人小丑
Рет қаралды 54 МЛН