Beko washing machine full of water? Check filter: How to!

[@katyenglish6554]

Thank you BootsOwen. Our machine wasn’t draining. We followed your guidance. And guess what. It was a HAIRPIN! Thank you.

[@beautifulsoul369]

Thank you I have the exact same washing machine and it's sold my problem thank you . IT WORKED save my self hundreds of pounds. 👍

[@lukekk2130]

Twice within a week, my patio cleaner and my washing machine! Your a legend mate thankyou!

[@bootsowen]

Good stuff, did you fix it all?

[@lukekk2130]

@@bootsowen yeah all up a running like new! 👍

[@Kim-MareeRyan]

We followed your asvice and that of the booklet . Was a bit of lint and a button . Cleaned out and drained. But still doing it .

[@mitziuk1]

Thank you. Ive an older model I think. Will show this to my son see if he can drain mine 🙏🤞

[@jjjones8233]

Thanks for this. Fixed it 👍

[@piecetoyou8285]

possibly pressure switch tube needs to be looked at or the pressure switch itself,tube may have damage, Or to the left you have a flexible drain rubber hose that comes from the plastic outer tub to the pump housing , you have a ball in side that shuts off the water and drops to allow water out of the tub, some times fluff or ball gets stuck causes issue, If the water don`t start to drain in time the machine will stop. if your pump don`t start in time the machine will stop, If the pipe to the pressure switch the machine will stop, especially if there is a small bit of powder or crap preventing pressure switch from measuring the correct air pressure in the pipe, this is done by water in the machine, that pushes air into the tube then the pressure switch triggers to next stage if all good , but if not good it will either keep filling or just stop program, Check brushes on motor if they are very low they will be intermittent, where the motor will no longer go into a spin, basically there are many issues that can cause this, look at all mechanical stuff then go to the electrical, If none of the stuff were blocked or damaged like the water pump may get to warm if its full of slug, as water needs to get into a section at the housing in the water pump , to help cool it down but not in the section of the magnet, , Take water pump out and firstly twist the housing off, then your left with back part of water pump with the propeller , now open up the round plate just behind the propeller. You will see all the crap in there, clean it out, when placing back together make sure the little rubber washer is placed back and the big rubber washer , Test pump for bearing play to see if it has to much wear ,this is the plastic that the propeller shaft runs through, if to much play this causes the magnet inside to shift and wobble to much hindering the the propeller to spin water on pump out correctly, Test the pump for continuity and its ohms, If its a washer dryer any the heating elements can cause machine to stop, Just go to the obvious things first check for blockages even your outlet pipe the grey thing at the back for any crap, and the u bend where the pipe goes into.or if goes to sink check cold grease aint causing semi blockage, if your machine wont spin due to not draining the water , but once you empty water then the machine will start to pump and drain suspect pressure switch or its hose, or the water pump failing , but another thing if brushes low on the motor and there is water in the machine it makes it harder for the motor to turn, ,but usually you here a humming noise, when the motor is struggling, One other thing ` if the machine stops like that , the door catch can be intermittent on its way out, I have come to realize the dam machines will stop due to a electrical failing at the time, or blockage, or heating element failing , or a part on the timer, or a part on the PC board starting to fail like a resistor or relay or a capacitor, Even the dam water inlet filter hindering the water coming in fast enough or the coils failing in them items for got the name, that control water to allow in to certain channels for powder or softener, Now this is the least suspect but should be checked , the filter capacitor, that controls the power into the machine, But be for grabbing it you need to discharge it from its stored electricity, please watch a video how to do so, or you will be getting a nasty shock, I hope I covered most stuff to get you thinking how to eliminate and work out trouble shooting faster.for the future issue,

[@Monsterpoxa]

I can’t turn it on after I cleaned it. There’s some water inside and it wont turn on. But I can open the door. Any tips?

[@jadabusaif4142]

I have an LG washing machine Last time I put it on A rinse spin. I Paused it on the drain cycle when I turn it back on to the rinse and spin it was trickling water into the drain hose I don’t know what to do it’s a quiz going into the drain I don’t know how to stop the washing machine so I tend it off and I did a spin know it works fine

[@0161M40]

I have another idea for will it wash how about the condenser at the bottom of the dryer

[@0161M40]

For will it wash could you do a big ice block or 6 litre water bottle

[@hollymoira3331]

Thankyou for the video, very helpful :) x

[@Simon-iv7ur]

Thanks a mil.

[@sarabonafede4996]

I don't have the black tube on mine🕳️sigh

[@junidastimbustamin728]

beko front load when quik spin water goes in and out. how to solve this problem

[@HeavensToMurgtroyd]

Lifesaver!

[@Ss0haib]

You have trained fingers, I mean putting them inside things

[@diannapetkova8578]

Does somebody knows what LJ symbol showing on display means? I have restarted the machine and it was fine after that but..still wonder

[@zacharyperezMME]

Rinse hold

[@A819A1L]

Help I can get mine to twist but not get it out it’s hurting my hand

[@bootsowen]

Have a look at my other videos. I show it in my filters playlist. Stuck or won’t turn. Easy to fix. Thanks

[@zenith2725]

Legend thank you!

[@Bekofan-oy7zc]

What cycle?

[@mrsdpurewal8067]

Thank you.

[@bootsowen]

No worries!

[@0161M40]

Or the concrete weight from an oldie washer

[@bootsowen]

I have done this a few times, look for beko ballast bounce?

[@jadabusaif4142]

Dude what time do a cleaning cycle on my washing machine

[@CL4SSiCS]

Every 2 months

[@jadabusaif4142]

I’m a fan of your videos do you do you destroy was the machine for your next video please

[@yalrikabi2007]

Jad Abusaif No

[@jadabusaif4142]

Think I will trust you does your not the KZbin channel guy he’s just he’s such a normal guy

[@CL4SSiCS]

@@jadabusaif4142 he will do lots more destruction videos :)

[@Thomas-tgggg]

Brother pls help me... My machine is working.. but it's not drying automatically... When he manually select the spin+ drain mode it will work . What the issue? Automatically it's not spin

[@bootsowen]

I don't know,

[@bootsowen]

How can I help?

[@Thomas-tgggg]

@@bootsowen any idea about the complainant?

[@lukyluky6632]

Worked a treat had bit of tin foil in there 👍

[@bootsowen]

Excellent, where did the foil come from?

[@und4287]

Why is the top of the door so gross?

[@Wasmachineman]

Sawdust.

[@CL4SSiCS]

@@Wasmachineman yes

[@semerahazam7172]

How do u open it

[@bootsowen]

What is there to understand?

[@sarune_5597]

What if I can't open the twisty cap? Mine feels stuck

[@bootsowen]

“Fix my stuck drain filter” search bootsowen videos! I have shown this!

[@ol_afs_musi_c8027]

Imagine if you opened it😱😫😨

[@bootsowen]

kzbin.info/www/bejne/nnOkZmupasp7r9k

[@nayman1398]

👍

[@КрасимираТодорова-х5л]

има черно маркуч за източване на водата

[@0161M40]

How about tools