Changing the belts outs on a Betstco EFGC-155 flail mower. The belts that came off it were 21", but they seem too short. 22" or 23" would be better.
Пікірлер: 17
@programacion73442 ай бұрын
Thank you for the video.
@msyotaboy2 жыл бұрын
Thank you for the video. I can't find this belt any where. I'm assuming its a standard 21 inch v belt? I can probably get a tractor supply?
@gcrmills Жыл бұрын
Yes. Sorry I'm late.
@spyadagani2 жыл бұрын
I have same mower and belts failed last week. What belts are you using? Not clear from your voice. Thanks.
@gcrmills2 жыл бұрын
These were cheap belts, as in the cheapest. They have held up for a year now though, I just don't let them smoke anymore is all.
@jamesdavis66783 жыл бұрын
Looks like rebuilding a Volkswagen bug motor in the car
@dougnicholas2317 Жыл бұрын
I have the AT 145 and after about 10 hours of use one of the belts and the tensioner craped out. It is impossible to change the belts. Just not enough give. The reason it failed is that one of the belts was installed upside down from the factory. I would not recommend the BestCo product.
@tacomafan74883 жыл бұрын
i just got same mower! what happened ? did you hit something?
@gcrmills3 жыл бұрын
I left it too low in thick grass a couple of times. By the time I heard it squeeling, it was smoking. Lasted quite a while after that though. They are 21", btw.
@AndrooH2 жыл бұрын
Did you NOT replace the tensioning nut?? You'll run into problems later on :/
@smallareafarming2 жыл бұрын
kzbin.info/www/bejne/aZuyi3SArKeHaLs
@gcrmills2 жыл бұрын
Well it was 2 years ago now, so far so good.
@wdk5353 жыл бұрын
Can't see a thing, dude. How old is that Betstco?
@gcrmills3 жыл бұрын
Turned 1 last week. Except for the belts failing, which was my fault, a bearing came apart on it. The welds and metal work seem good though.
@alisaid31822 жыл бұрын
How to change the oil please
@gcrmills2 жыл бұрын
You might have to turn it over, and let it drain out the filler.