Big Tire Garage | Season 2 Episode 14

When dealing with a Turbo charged engine there is a lot of plumbing that has to be dealt with. This week Ian tackles everything under the hood of the Willys Wagon that is needed to make it run. Plus he takes care of some creature comforts as well.

[@bigcountry4262]

Nice work. I’m about to retire and start a project truck with my son. This is good inspiration.

[@yukongearandaxle]

Congratulations on retirement, Mark. Good luck with the build

[@jamesrobinson5801]

Mr. Ian Johnson...Finally found you. Didn't know what happened to you for a long time. One minute Im following up on a Survival Suburban with Dual Axle Rear then you went missing and the show went right out the Exhaust Pipe. I couldn't continue to watch after you left. Guess its to Big Tire now...Awesome

[@rickmetheny5687]

MAF sensors are usually calibrated for the tubing size. I'm not sure what the R2.8 uses MAF for (fuel control? EGR?), but it's something you should keep in the back of your mind when you test drive it for the first time.

[@stevea3936]

No questions asked! Thanks for the hangover. Just kidding. Ian you did a fantastic job commentating on KOH.

[@PaulKaiser42]

That’s really cool (haha...see what I did there)!!! Seriously awesome build👊🏻👊🏻! Love watching this series

[@markphilpot8734]

Go Ian, keep whoopin’ that truck’s ass! I know when I see you fabbin’, it’s as good as done! Press on sir! Stay safe mates!😊👍🏻😷

[@ianmead216]

That is a beautiful project Ian!!! Congratulations

[@frediefarmer]

I love your builds. This one may be my favorite 😻

[@lesszabo5625]

That is just pretty doggone sweet to hear that purrrrrr!

[@Lunatic_Lou]

Watched the wiring video and have a question……. How do you remove the body with the AC hooked up?

[@bradmiller2464]

I can't wait for the commanche.

[@timoneil9612]

Nice , I'm looking for the rear cab corners and back wall to make my CK 7 into a truck . Any suggestions ?

[@adamUDavies]

Ian , I'm wondering if it is possible to install a Honda 3.5 in a jeep ? New challenge for you ? Would make a great episode

[@davidbartlett5604]

Love the project!

[@allanwagner4570]

too bad you could not find someone better than Ian for your video no Yukon gear & Axle for me ever again

[@fredmertz3837]

Congrats

[@Icecold185]

Hair.

[@fredmertz3837]

Where is your shop dog supervisor?

[@markomarkic590]

Wrangler yj 1991 years engine 4.0 pcm 56026982 need new number part for new pcm Thanks From BOSNIA

[@joecataldo2908]

Whoever does the video and editing does a good job but whoever does the title to these videos must be confused I have no idea what you’re working on before I click on the video that would probably help get more clicks