BISON SSR 400u 4WD UTV: Starting Issue Fix | Solenoid Replacement

[@paul-u9j3k]

Thanks for the video. I purchased one and there is virtually no videos for maintenance, other than an oil change. I couldn't get my drain plug loose, so i had the dealership change oil, $165.00, still cant get drain plug to loosen, and i need to do another oil change. Good job!

[@One44Special]

You're right there's no videos out here for the bison 400. So thanks for doing this one. I was getting no error code. But the light for the shift position was staying on and it was flickering.Bright dim almost like a turn signal. Also, my fuel pump would come on for 5 seconds.Go off for about ten and keep cycling like that Until I disconnected the battery. Today I hooked it up to start it and when I Started it the starter didn't disengage. Now I have a code: P0351. So i'm thinking I have the same problem.

[@Lawnmowercare]

I always try to start with the most affordable options that could fix issues. Solenoid under $12.

[@Lawnmowercare]

I had to disconnect the battery because the starter would not shut off. Originally you could just touch the disconnected cable to the battery and you could get it to start but as soon as you remove the cable, the engine shuts off. That’s why I tackled the solenoid!

[@Lawnmowercare]

Did you figure out your issue? Was it the same problem?

[@speckhunter84]

Where did you get the solenoid at? Also part #? Mines doing the exact same thing any info is much appreciated thanks

[@Lawnmowercare]

@@speckhunter84 a.co/d/iGQ1XYQ