Blender 2.8/2.9 Pave Pendant Design & 3d Print - Pave Part 1

Hey Guys; This is part 1 on creating pave settings. I Made this a couple of times, and ended up 3d printing the design... This is a simple way for those of you who want to know how to do this in Blender to get started. Pave on Flat surfaces in CAD is easy. In the Next Pave section, I'm going to be covering arcs, curves and domes. It will be a lot more complicated, but much more rewarding!
For a list of the tools and equipment I use every day, check out my Amazon Page. These are products I use and recommend. All purchase you make there do not cost you extra, but I get a small commission for sending you there, and every little bit helps! Thanks.
www.amazon.com/shop/petergran...
If you like these videos, please subscribe and give a Thumbs UP!
Every Little Bit Helps!
For more jewelry and watch related repair info, visit my website at
www.myjewelrybench.com
If you would like to help keep this channel funded, consider
a donation at
www.patreon.com/myjewelrybench

[@joe_scotto]

This was extremely helpful! Please please please make the second part!

[@angelavolkov1126]

How wide does the recessed area for the diamonds have to be in relation to the diamonds?

[@dzmecanic5157]

Great video .i have question why u had used all transformation before u gone to edit mode thank you have great day

[@federicomondini205]

thank youuu

[@ultraduck171]

This is really helpful! I was wondering, did you ever release part 2 of this? I couldn't find it on your channel.

[@watchesandjewelry]

Hmmm. Don’t think I did!

[@JC6411]

Nice video! Is there a way I can reach you? I have a bracelet design in mind, but I'm running into some issues regarding the design

[@watchesandjewelry]

You can send a message to me at Facebook.com/myjewelrybench