Blue Printing Golf Clubs

[@charlesbartholomew2910]

Outstanding presentation and explanation of blueprinting, Jim. Loved this one! I'm sure the golfer that gets these clubs, is really going to enjoy using them.

[@McGolf]

Thanks Charlie

[@mattrevilock5890]

Nice catch on the lie angle. Great content Jim.

[@McGolf]

Thanks Matt

[@1striperon]

I was expecting the 7 iron demo to be off spec, and that the other clubs were matched up to the off-spec configuration because the golfer hit it so well. I don't know why, but it just popped into my thoughts. I am trying to come up with a trip to Ohio to be fitted and my bag to receive your attention. You are the guru, Jim. Maybe after my wife recovers, whenever that happens. I have a brother-in-law in Vermillion, OH to visit. 😄

[@McGolf]

The wife recovery is far more important. When ready just give us a call

[@johnnewcomb5162]

Great video! It made a difference on a set i had made years ago. Question I just bought a set of Ping Eye 2 irons mint with original grip's probably seen 3 rounds since new. Problem is the shipper put the clear shipping tape directly to the club head's even inside the cavity, took a ling time just to get the tape off. Any idea how to get all the glue off the club head's without messing up the finish? Thanks

[@McGolf]

Try a little acetone on a paper towel and rub gently let dry then try again, when soft you might be able to take it off with a thumbnail

[@robinmccleery3968]

Great video! ❤

[@McGolf]

Thanks

[@raventalks2776]

Does the long, skinny grip removal “slim Jim” mess up the shaft? I’ve seen a lot of people use them & it appears to be simple using it

[@irod97]

depends on the user. its my preferred way of doing it. having a steady hand and a lot of solvent handy helps. You can also use air with a large gauge flexible tubing over the grip to prevent the grips from blowing up. I wouldn't recommend that method on corded grips though.

[@McGolf]

If steel not really. However, I found them to be clumsy other have had really good success

[@danieljordan3462]

What about the splineing, most assemblers do not pay attention to this so that they can get the labels all in the same place that puts you spline way off

[@McGolf]

That is true in a lot of cases. However some golfs prefer logo down and that’s that. Nippon has figured out to get the Flo in the logo down position for me