Blueparrott b350-xt speaker fix

[@sothapreetbhullar5132]

Can you tell me what kind of wire you use in this device

[@courtneymullings3190]

Good job, very instructive.My microphone stopped working. I took it apart after watching your video. I noticed a third wire of heavier gunge attached to the printed ckt board next to the two red ones that go to the speaker. I found that gray wire hanging loose. Not sure if it serves as an antenna and should be left loose or where it should be connected to. I figured it should be going to the boom microphone, however, I don't think I can open it. Waiting for your response before I put this headphone back together. Can you help? I have the blue parrot 350xt

[@walz04736]

Spinning the wire like that also helps with less interference in network wires.

[@spgilmartin]

Where did your get the wire to replace the old ones?

[@BP-by1zb]

It's funny someone that's got enough patience to work on fine detailed electronics doesn't have enough patients not to rip it off his head sling it across the room lol

[@sleftwich10]

Thats funny!

[@circuitmonkey6653]

Ok, but did you actually hear anything when you turned it on? I just replaced the wires on mine(same model) and realized when I cleaned of the soder pads on the speaker, one side is marked for polarity(+). The board is not. Made my best guess and while it turns on and the LEDs work, no sound. It partially worked before, but the sound would cut out if you moved the mic at all.

[@sleftwich10]

Yeah it sill works to this day.

[@vikings844]

sleftwich10 How did you take faceplate off?

[@GhostreaperX85]

vikings844 that's what I want to know. I've got a bad speaker wire 😡