In this video I show how to remove a transfer case from an E90 335xi. A little bit of patience and a few extensions gets the job done in few hours. If this video helps you at all don't forget to subscribe and like!!
Пікірлер: 8
@arichie_rich6 ай бұрын
Yoo this video just made my whole day. Same car. Same problem. Doing the job when I wake up in the morning. Not removing the exhaust is HUGEEE. This video👌🏼
@garagegrunt81546 ай бұрын
I was unable to find this anywhere and I knew there were others out there that needed this! Good luck and don’t forget to subscribe!
@michwalt36022 ай бұрын
How did you get the forward facing top bolt? I can't get pressure on the back of the ratchet to turn it.
@garagegrunt81542 ай бұрын
I used the flex heads (flat) from harbor freight and was able to get enough leverage for all of them. You can always use a pry bar or a screw driver to leverage pressure onto the back of the ratchet.
@michwalt36022 ай бұрын
@@garagegrunt8154 Thanks. I got it.
@luluhus1Ай бұрын
I just did this today. Honestly it's extremely easy. Long extension, a wiggle bit and an E12 Socket. The trans falls just enough.
@luluhus16 ай бұрын
I just need torque specs.
@garagegrunt81545 ай бұрын
Unfortunately I don't have torque specs. For the case, I tightened it down until its very snug, don't crank it down.