Wasn't bad at all. Had it all done in under an hour and registered with ISTA Thanks for the great how-to!
@ZoomIDoRx84 ай бұрын
"if you don't Trust your calibrated wrist, use a torque wrench" Priceless!! Love it!!
@fcpeuro3 ай бұрын
😂
@harryrjones5975Ай бұрын
Gareth you look good boss. Great video too.
@davidmartin123Ай бұрын
I sliced my left index finger too on that thin metal clip swapping out my 2012 335is battery. My 4-year old dealer-installed BMW 90 AH lead acid battery failed catastrophically last week. I replaced it with a made-in-Germany Walmart Everstart 95AH AGM. Both H8. Installed, coded and registered the new battery. Yes, that short-bolt battery hold-down bracket is a bear to reinstall. I set it aside out of frustration. Tonight after fiddling with it for about an hour, I was finally able to lower both the bracket and the stubby bolt in place by stuffing some plastic wrap around the bracket hole to keep the bolt from falling out (oh, that's what the O-ring that fell off was for!) I lowered it with my scrunched left hand sideways holding the bracket with thumb and healed index finger and eventually got it lined up with the threaded hole, then hand-tightened with right hand with a 10" nut driver extension bar. But yes, a longer hold-down bolt would have made the job much easier!
@IOSALive4 ай бұрын
FCP Euro, I really enjoyed this video, so I hit the like button!
@fcpeuro3 ай бұрын
Wooh!!
@IOSALive4 ай бұрын
FCP Euro, You're the best! I subscribed because I love your content!
@fcpeuro3 ай бұрын
You are the best!
@jovaneghtesadi14944 ай бұрын
Super helpful! Thank you!
@fcpeuro3 ай бұрын
Thank you!
@shreedevi20054 ай бұрын
The biggest pain in the ass battery to replace. Also the way the battery is placed and the weight, it's hard to lift it out of that enclosure as well. I had to remove the battery and put it on a charger a couple of winters ago. It was a nightmare but nice howto video. Moral of the story, drive your car all year long and don't let the battery go down.
@fcpeuro3 ай бұрын
💯
@snow41man4 ай бұрын
@fcpeuro have you been able to address the negative reviews recently with the battery?
@nycshelbygt5004 ай бұрын
Going Li-Ion Battery on my BMW E9X M3. It only weighs 18-25 lbs and can be shipped. It shuts off when the battery is low, so you have enough charge to start the engine. There is also a simple Battery Cutoff device if you store your car for months at a time. Connects to the existing battery terminals.
@fcpeuro3 ай бұрын
Sounds like a nice touch!
@freddyb81gtx20 күн бұрын
Is there a different way to register your battery
@miguelmaldonado988112 күн бұрын
Question, why does the Odyssey h8 battery at Autozone come with a black plastic top instead of red
@nzprogameralex4 ай бұрын
Good job there. Do you have any recommendations for the quick-release external battery charger connection point? I have the same one as you do in the video for my E92. Also, are there any alternative scanning tools you would recommend? iOS or PC-based software?
@aaaaachew4 ай бұрын
Is there a trickle charger that works without having to be plugged in? I am thinking of a car that's parked outside in the winter for example.
@kennethstevens1107Ай бұрын
Do you need to have an auxiliary 12 v power source connected when exchanging the battery, to avoid loss of preset parameters.
@fatonkomorani8778Ай бұрын
❤
@davidmartin123Ай бұрын
Battery was disconnected from car about 30 minutes. I didn't lose any preset parameters. I just needed to set the time in iDrive after connecting the new battery.
@FrancisD-d1wАй бұрын
Hi there my battery is dead in my bmw e92 does anyone knows i can put a normal battery in it instead the double expensive agm one? And somehow just disable that useless start stop system? Thanks
@duck748r2 ай бұрын
If there is a vent tube, then no reason to not use it just like it came from the factory.
@davidmartin123Ай бұрын
Yes, if there a hole in the battery for the vent tube, probably a good idea to reattach it. And use a stopper plug (usually included with new battery) to seal the hole at the opposite side of the battery.
@vargasaidan73664 ай бұрын
There is no part number for the battery hold down screw. :(
@fcpeuro3 ай бұрын
We have both styles listed on FCPEuro.com! www.fcpeuro.com/products/bmw-mounting-screw-61217577620 www.fcpeuro.com/products/bmw-hex-screw-with-collar-m6-265mm-07147211160
@kennethstevens1107Ай бұрын
When replacing the battery do you use an auxiliary 12v battery source so no stored values are lost?
@adrianlala50444 ай бұрын
Easy peasy right lol😂😂
@fcpeuro3 ай бұрын
😂
@mfujiii4 ай бұрын
Surprised you guys dont have an S65 rod bearing replacement video... maybe this car is the guinea pig?