BMW S1000R 2010 - 2016 Brembo Caliper rebuild

[@radiocrash]

Best to run a pic around the piston seal channels to clear out any corrosion.

[@castleclubclipz]

Can you do a video like this for the rear caliper too? Including how to remove the caliper from the bracket?

[@TheScortUK]

Great video - thank you for taking the time to film and upload it! Noticed my pistons had a bit of corrosion on when I did a basic clean a few months back, so might make this job a winter project (that and adding gel to the seat!). I presume you had to flush the fluid afterwards, and issues with the ABS system when doing that, or is it as straightforward as a NON-ABS flush? Cheers

[@SpaceManDan]

Hi sorry for the late reply! You don't need to flush the abs side.

[@lDDD587]

Instead of using that spanner wrench you could just use an air compressor to get the pistons out.. I've done that for one of my vehicle caliper rebuild. Just don't use alot of pressure that that shit will shoot out hard as fuck! 😂😂

[@Jason-ry3et]

No leaking since doing this?

[@radiocrash]

Leaking from where ?

[@SpaceManDan]

Why would they leak..