Рет қаралды 28,188
Thanks so much for stopping by to check out this anticipated comparison video!
Overall, I feel the Bondo spray putty is going to give you by far the best results in the fastest time! Let me know what you think by dropping me a comment.
Links are below for proper set up, ppe, products used & other recommended products!
Check the video index below for specific parts of this test!
If you're using this method make to sure to let me know by tagging me on facebook or instagram with before and afters!
My part 1 & part 2 ppe video
• Finishing 3D prints: a...
• Finishing 3D prints: D...
Uncle Jessys video @UncleJessy
• Smoothing 3D Prints by...
Video Index
Intro & what's in the video 00:25
Starting off the test & how to prep your 3D prints 01:32
Comparison & importance of putty set up/filler primer 03:20
1st coat of spray putty & airbrush comparison 03:36
1st sanding,2nd putty coat & 2nd sand 04:40
Why i had to do a 3rd coat and benefits of bigger nozzle 05:25
Sandable primer inspection & final primer coat 06:30
Starting the filler primer set up & early coats 07:06
Inspecting the spray putty faceplate & results 08:15
Faceplates after 3 cycle coats of filler primer 10:53
Inspecting faceplates after 1st sand & sanding tips 11:30
Krylon after 1st sand & tips when using kyrlon 13:05
Truths of acetone, proper ppe & wha'ts exactly in those aerosols you use 14:45
Final shots of filler primers 17:15
Putty vs primers cost, time efficiency & pros & cons 18:50
Time logs for putty & filler primers 19:51
Covering more pros & cons of these methods, ppe, set up & more 21:08
More of my thoughts, tips, thank you's & more 22:52
Products used & recommened
Bondo glazing putty
amzn.to/3wgsUT2
Airbrush
amzn.to/3NcHxfG
Battery powered airbrush & .5 nozzle
amzn.to/3FRm8Gy
amzn.to/3PzZTcH
Spray shelter
amzn.to/3G2sC5z
Small compressor with airbrush $60!
amzn.to/3PnmBVi
3M respirator
amzn.to/3yDYfQV
Bondo filler primer
www.acehardware.com/departmen...
Duplicolor filler primer
amzn.to/3Nj0ey6
Krylon filler primer
amzn.to/3LhYhRt
Thanks again to all my subscribers & one last shot out to uncle jessy! If you're not subbed and you want more in depth tutorials, builds & 3D printing tips & tricks smash that sub button!
Thats it for now, thanks again to all my subs & viewers, until next time DW out!
*******Contact info & social media**************************************
Contact me anytime - Darkwing_dad850@yahoo.com
Instagram- Darkwing_dad850
Facebook page- / darkwingdad850
Like my art? Visit my etsy store & get your own!- www.etsy.com/ca/shop/DarkwingDad
Join the darkwing discord!
/ discord