Bosch GMF 1600 CE Professional Twin Base Router - Product Overview 1

[@eniszulufepustampasic2799]

Unfortunately, the router is complete garbage! The main reason for buying it was two bases, a plunge and fixed. The idea was to mount the fixed under the table and use plunge in other cases. Fixed base does not work at all! It is supposed to be fine regulated with screw but the motor cannot move inside the base at all!! So, money down the drain! O.K. I said, lets buy a professional table plate from wood peckers... and another problem rises. First the motor does not measure like any other supported by most of plates so there is a problem mounting it and the second, the power switch is not on the motor but on the base so you cannot use the motor out of the base. Not to mention that same tool in USA is caller MR23... so when you are tying to found a plate for GMF1600 in USA... is like trying to find an ice cube in the desert... I have manage to overcome most of the described problems just to figure out that it would be nice to have a few Watts more.... so... After all the problems it ended in garbage and I have bought a Festool OF2200 which is 3 times more expensive, but worth every single cent !

[@matthewhoare6641]

I have had one for 9mths or so mounted in my router table and its rubbish I am forever having to remove it for cleaning as it get clogged with debris and adjustment above the table is awful and now it starts and immediately goes off,its going to Bosch today to be repaired under warranty I hope,wish I'd never bought it

[@franciscoochotorena9202]

I´ve got one, and it works very well. But when I try to use the fixed base in my router table, and I try to raise the motor whit the hex wrench, frecuently it locks.

[@nicolasherrbach3757]

Excellent explanation. The only video describing all the features so far. Thanks!

[@segfaultii]

Kinda late but what bit is that at 6:07? I am looking for a long cutting bit

[@pf5658]

Unfortunately this does not come with edge guide and possible no case in the US. Guide listed as separate purchase on Amazon.

[@Norwegianwoodworker]

Nice. I had planes of a new Festool router but will be checking out this one first. TR

[@farmerbob139]

I have this router. the plunge base will not stay locked in position for more than a few seconds. it is very frustrating. it generally moves away from the work such that you don't notice and have to go back over everything again. especially infuriating using round over bits. otherwise it seems like a very good quality tool.

[@Along198086]

I also planning to buy this unit. Can u please make a video to show the failure of the plunge mechanism as you described ?