Nice work, obviously not your first rodeo. I have done many of these repairs over the years and have to say the size of those beams are overkill.
@andredavis20364 жыл бұрын
what size ibeams? any specific weight, diameter? e.t.c?
@nateespino77804 жыл бұрын
Where did you buy those I beams with flange and holt holes on the bottom?
@JRESHOW3 жыл бұрын
Thanks for the video. What do you call those beams? I can’t find any with the mounting holes for drilling to the floor.
@bwing4113 жыл бұрын
We had some made by a local steel work company. Just call around and ask, its really common for the I Beams to be used, we just asked them to weld a flange on the top and bottom with holes in it for bolts. Very simple, think it cost like a couple hundred bucks per beam, for the full thing. Much cheaper than $500-800 a company will charge you.
@rich_ez27012 жыл бұрын
Good walkthrough.
@dmuhlarik3 жыл бұрын
Did you excavate the outside of the wall before you pushed the I-beams against the base of the wall?
@larrys84283 жыл бұрын
That would be the complete fix with the beams. Stop the problem at the source first.
@camo825715 күн бұрын
How deep do you put the rebar intonthe ground for the jack?
@powerofknowledge77713 жыл бұрын
Thanks for sharing the video! Great idea! Can you answer everyone's questions in the comments below your video? I have many of the same questions.
@IvanBohannon4 жыл бұрын
When your walls are bowed, how much will you jack the post at the bottom before you bolt it in?
@JohnAvantiBK2 жыл бұрын
The wall is still bowed though...
@doughart48334 жыл бұрын
Hey I used to do some home rehap and I'm close to your Area ..I'm trying to start a small buisniess I do trim carpentry work drywall painting ..and such if you ever need my services feel free to get back with me
@EmpireTextbooks3 жыл бұрын
What’s the best way to alleviate pressure on the other side of the foundation? Putting more soil close to the foundation to make the grade go away from the house or digging out the soil next to the foundation to alleviate pressure from the foundation?
@daleravic3 жыл бұрын
Pressure relief system on the inside. Trench, weep holes in the blocks to the sump.
@ThePikmin182 жыл бұрын
@@daleravic technically best solution is digging, filling the cracks on the outside m, and waterproofing the exterior. Then You wouldn’t need a full Interior permitter drain system. You would just need good grading and footer drains
@Luckingsworth2 жыл бұрын
@Bob Jones no!!! The issue is water on the foundation in general. Whether that water seeps in makes little difference. The freeze thaw cycle of the soil will still push it in.
@glennlienhop342 Жыл бұрын
Try se
@deebosmith4614 Жыл бұрын
Nice
@bongdallion34352 жыл бұрын
i never could tell what filled the gap between the beam and the perpendicular joist?
@JaysToDoList5 жыл бұрын
Nice how far apart should I space my wall beams ?
@CompThatHouse5 жыл бұрын
Good Question. They are about 5ft apart in most cases.
@Z-Ack5 жыл бұрын
wafrp.com/wp-content/uploads/2018/06/2017_UBC_Foundation_Repair_Code.pdf Theres a link to the 2017 structural foundation repair guidlines.. eerything they did is relatively correct and to standard but engineered opinions are good to do for most as there are many unseen and overlooked aspects to doing stuff like this.. the spec in the pdf is a base guideline for engineers when writing up a build plan for contractors to follow for safety..
@Z-Ack5 жыл бұрын
That said theres different shit you should do depending on the construction of the home, foundation, joist layout and supports, footings, grades and external factors like soil type, drainage, extent of damage, water intrusion, previous repairs etc...
@ginacochran62924 жыл бұрын
@@CompThatHouse what size are the I beams?
@jc98344 жыл бұрын
@@ginacochran6292 4w 13
@omarferman99773 жыл бұрын
whats the average cost for this?
@lowellirish8 ай бұрын
All over the board from $15k to 50k depending on severity
@vitaly6312Ай бұрын
15-50 is insane. I’ve gotten estimates on all 4 walls from 6 contractors and the highest estimate was $8500. For beams and installation obviously.
@MattLong65 жыл бұрын
Sounds very professional, and very thorough!
@SillySacJac10 ай бұрын
Where are u located ?? Curious
@Z-Ack5 жыл бұрын
Like how it said screwing in bolts and it cuts to mr beef kung pao fire chops over there hammering on the fugger.. ha.. good deal tho pickle. In Fo Tainment...
@iap66472 жыл бұрын
That’s most likely a concrete expansion/wedge anchor bolt. Drill the hole and pound in the anchor bolt, then drive it in and the anchor expands.
@hjwang44772 жыл бұрын
is this special I beam? i cant find ones that has bracket at the bottom for bolting in.
@forensic83857 ай бұрын
Those are just prefabricated with a plate welded on the end. You could do something similar with a clip angle.
@Angel-lx1xn2 жыл бұрын
Thank you
@glenharper31362 жыл бұрын
That's wrong. 1st you straighten the wall then brace it! If you think it go back by itself your crazy!!
@trevor5290 Жыл бұрын
Sure.. nothing could go wrong excavating backfill up against a bowing and moving wall. First you SUPPORT the wall then you can remove the dirt outside to add a frost barrier or fix what ever is causing the problem.