Love the videos, and especially the clapping when your done!
@chrisjordan58067 жыл бұрын
you sir are a champion wish i would have seen this years ago. i learned the hard way thanks for sharing
@krnaR1998n7 жыл бұрын
Excellent video, one of the best explanations.
@ricktruelove10 жыл бұрын
Thank you, Professor!
@duncanmwangi83793 жыл бұрын
Thanks, from Nairobi kenya
@JD_Spencer7 жыл бұрын
Ive noticed that when calculating the length per single unit foot run using the Pythagorean theorem vs the length per foot run listed on the carpenter's square, it's off by .02" or 1/32. This isn't such a big deal on one unit length but when you multiply that over 1/2 the length of a 40 ft building, that 1/32 turns into a half inch. So, you could conceivably cut your board a 1/2 too long or too short. How does one account for this? A half -inch short if you use the square multiplied vs Pythagorean Theorem
@chiller191004 жыл бұрын
Thanks for this video. I just have two questions, how is the line length 18 inches and why is the number of units 4? Thanks. Just a little confused at the numbers on the white board
@danielsteele75448 жыл бұрын
sorry about that comment,you did in fact cover dropping the hip,I was on the classic work site and ended up putting that comment on Brads sight.Very good video,watched it at least 10 times very carefully.
@romand1235 жыл бұрын
Is there a standard dimension for birds mouth sizing? Great tutorial!
@thembinkosikunene49383 жыл бұрын
The fractions are confusing for those of us who use the arithmetic measuremennts.
@danielsteele75448 жыл бұрын
you didn't mention cutting the seat cut a little deeper so as to allow the hip to come into line with the other rafters to aid in sheeting,have you heard the term backing? I understand backing isn't done anymore,and the hip is just dropped to achieve the same result.
@tillmansr20023 жыл бұрын
Very good video, at
@jesusvillasenor69024 жыл бұрын
Muy bueno tu video teacher
@drweidler6 жыл бұрын
I thought the seat cut could not be more than 1/3 the width of the beam. Is that different when framing a hip roof?
@dennishala4872 жыл бұрын
Do u do the same with shortening the valley?
@dexterforeman5 жыл бұрын
Need stair gauges
@mauriciobermudez56735 жыл бұрын
Buen vídeo pero me gustaría que lo traducieran al español gracias
@vincentczarnecki5 жыл бұрын
This is not the union way
@advancedjoomlatechniques95898 жыл бұрын
Brad, other videos are indicating that the second plumb line (HAP CUT) is measured from the center line of the cheek cuts. You measured 2-1/8th further back which was from the end of the rafter. Seems your rafter is going to be short? Which is correct?
@dennishala12722 жыл бұрын
What if it's not a 2by? Will it still be inch and a 16