CV Fabrication Hot/Cold Pipe Installation on Gen 3 Raptor

[@sparda1123]

Nice video, I did the same mod a few weeks ago and it was annoying that there were no instructions. Turbos are definitely louder now. I can't comment on performance of this alone because I did intercooler, turbo Inlets, lower temp thermostat and down pipes all at the same time. What I can say is the mid range is definitely more punchy from all the mods. I'll be going to MPT soon for full E85 tune, injector and pcm swap (I'm 2023 also) stay tuned.

[@WaterFowler41]

Awesome! Yup, I was scratching my head for a long time trying to figure out which pipe went where. Hope this helps other folks! Keep me posted on the tune! Curious of your thoughts.

[@sparda1123]

@@WaterFowler41 yea it helps to take it all off then figure out what piece goes where. The other annoyance is the clamps they use have super long threads. But yea I'll keep you posted post tune. I'm sure it's going to be absurd.

[@BRTbike-fz5fn]

OK kinda confused here. Was your other vid installing he CV intercooler after the charge pipes install? Saw stock pipes on the other vid and stock IC on this one. Both are great vids by the way👍👍

[@WaterFowler41]

First video was the intercooler with stock pipes, this video is CVF pipes with the CVF intercooler. That said the install process is the same even if you have a stock FM intercooler.

[@BRTbike-fz5fn]

@@WaterFowler41 Gotcha yeh I got your vids confused with another install I was watching where he did the Titan with the silicone cold pipe boot.🤦‍♂ Just saw the OEM cold pipe connector for the Titan 2 on your install. Thanks for the reply. Keep up the good work

[@pokfliedlice]

So, I've seen these and aFe pipes. They are both aluminum, but CVF is more than half the price of aFe. I already have the Titan V2, and leaning towards the pipes vs aFe, other than the price. Not sure why the difference? Any performance update?

[@rgrkim]

Could you clarify if this pipe is intended solely for the factory location intercooler, or if it can also be compatible with the Cobb FMIC?

[@WaterFowler41]

It works with my Titan V2 FM intercooler which uses the same pipe locations as factory. I believe the COBB FMIC also uses the same pipe locations so by proxy, I would say, yes these will work for other FMICs that can be used with the factory Hot/Cold pipes.