Broken surfboard repair - Complete movie

[@pangrac1]

Too much resin in the void of broken are make it heavy. Better will be glue it tight together with resin mixed with microballs and than normally glass it over.

[@kjskjscjs]

The sound of that drill cutter at high speed makes my teeth think I'm at the dentist.

[@Surfmus]

For a stronger repair. You should've create a complete one piece stringer. Split the foam-blank in four since it broken in half other wise split it in two to create the blank. Next step glue the pieces of foam/blank to the new stringer. Then relaminate the whole board. This on the video is quicker but not nessesary stronger and the alignment has to be perfect or you'll get a kink. If it's still working and you don't feel the misaligment/kink, then you did a good job!

[@AtheistCook]

nice repair, i would have added two layers of fiberglass fabric to the broken area to strength it.

[@jpalmeida2379]

This way of repairing the funboard becomes heavy, it has to use microsphere and when it is laminar to use the espatular!

[@timedrifter117]

I used super glue it works good

[@johnnyv2032]

What’s the top coat?

[@neil2385]

Great video but the sticks do not do much. Send me a note and I can tell you the exact way. We have done many and they all work still

[@jmiguels2007]

Don Carbon , Thank you for your comment. In fact it is riding since then. How would you do it to make it stonger? Bigger sticks? It is an already very old board but the outside layer is much stonger now than before. I'm not going to open it again unless it breakes again. Ideas are wellcome. Thank you José Miguel Santos

[@neil2385]

Private message sent

[@dadouziane2463]

nice job

[@smokeydabeecharlescoleman8365]

How was it broken ?

[@jmiguels2007]

It was in a wave in shallow water and the board fixed in the sand floor...

[@andrealfing]

It will broken again

[@jmiguels2007]

It is riding with no issue. Note that it is not just the sticks that provide the strength there is also the epoxy and the fibre reenforcement band arround the critical zone.

[@Johnnyrad1683]

Sticks, id a gone down to the hobby store bought carbon fiber and or carbon rods. Good job hope it lasts.

[@wilsonferreira1641]

So bad