BTT - Manta E3EZ - EZ2130

[@NathanDavidDodd]

Thanks Ed. I was ripping my hair out trying to get the ez5160 sensorless homing working. Yes, you are correct the pin define is incorrect from BTT docs. Ouch. You did it correctly. Although the Klipper docs do say to use the pullup resistor ^ as well. I am not sure its needed. Maybe on reboot so it stays high? Thanks again, I find your videos super easy to follow and you take alot of time to do so. Appreciated and respects. Keep them coming please.

[@tomandrews5392]

Ed everytime I start a new project you have the answers THANK YOU

[@EdwardBraiman]

You're welcome.

[@D-train69]

What is this for what are you doing here??? Did this board come out of a Pioneer elite amplifier???

[@EdwardBraiman]

Theses are special 3d printer boards for 3d printers.

[@D-train69]

@@EdwardBraiman O ok gotcha. I pulled apart a pioneer amplifier and was wondering if the transformer in it is the same as one out of a microwave??? I know this Is a off topic question but you seem knowledgeable in this subject. They dont need to match up exactly the same just wondering if the function is the same. Any feed back will be much appreciated, Thanks.

[@EdwardBraiman]

Unfortunately I do not work with amps, but I'd advise extreme caution due to shock hazards. Normally reading datasheet for electronic parts is advisable.

[@D-train69]

@@EdwardBraiman Thanks for the feedback Thank you

[@EdwardBraiman]

You're welcome.