Bucking a White Oak for Mill Logs

[@OutoftheWoods0623]

nice save on that Oak,

[@urbanlumberjack]

Thank you!

[@Cutting-with-Paul]

Great job , nice wood . Give it a bit more Low jet on the 660

[@nicholasblohowiak29]

@@Cutting-with-Paul I’ll have to try that with mine as well. Thanks for the tip.

[@Cutting-with-Paul]

@@nicholasblohowiak29 sometimes , if it starts like that , or needs to start with your hand on the trottle , its a low jet problem (if it holds idle) if not , its simething else , coil problem ... fake air .., depends

[@nicholasblohowiak29]

I have the same problem with my g660. I just hold the throttle, and pull it on the run chock position about ten times and it usually starts.

[@urbanlumberjack]

Thanks, man, I’ll try that out. Sometimes this thing will just pull my shoulder out of the socket. Would love to have it running reliably again.

[@urbanlumberjack]

Thanks, man, I’ll try that out. Sometimes this thing will just pull my shoulder out of the socket. Would love to have it running reliably again.

[@nicholasblohowiak29]

@@urbanlumberjack You’re very welcome. I hear ya man. That thing has so much compression it’s insane. Even when I’m pushing the decompression button. But the saw is very powerful. I’ve had to replace a few things on mine and the OEM parts so far I’ve bought have fit perfectly.

[@MattKeevil]

That's a lot of tree!

[@urbanlumberjack]

It’s a big one! Hopefully lots of lumber going to try and quartered a good bit of it