build guide X7 3D printed RC Raceboat

[@600bubba]

I used a ztw 60 amp 2-6s ESC on mine and with twin 1400 mah 60 batterys and a 4319 prop gotten 56mph so far next is to carbon inlay the boat

[@Bash_Tech_]

Wow that's fast. Can you post a video? I'm curious😁

[@NevskiyVladislav]

Задних стабилизаторов должно быть два. Катер кренится в повороте и один стабилизатор либо погружается, либо всплывает. Поэтому он будет работать только при повороте в одну сторону. В другую - корму будет сносить.

[@CLPOZ]

should have labled or added txt to video saying wat each part was used for as in the hardware it takes or add the list to video description nice video tho just hard to understand im going in on a limb printing this now

[@Bash_Tech_]

Please check out the word document attached to the print files. There is everything you need to know in written form. Happy building. Hope you like it. And also check out my other boats

[@oldschoolstu]

Where can I abstain the plans for the cat. 450 cataraman?

[@Bash_Tech_]

Check the link in the description

[@ch.nuschnusch3898]

The drive shaft must be in a greased stern tube because otherwise water will run into the boat and the plastic will melt at high speed

[@alvaroespinosanavas5033]

he imprimido el barco pero a la hora de navegar la helice toma aire y no avanza correctamente, alguna solucion?

[@Bash_Tech_]

Hi, you need to sand the surface of the propeller and sharpen the edges. Otherwise it won't work. I tried different settings to get a usable propeller right from the Printer but it was either to weak or it cavitated like you describe it

[@tonyschill8054]

What is drawing water thru to cool the motor down?

[@Bash_Tech_]

it's just through driving.

[@hanseschiff]

sharp optic.

[@hanseschiff]

please laminate carbonfiber. optics, stability, quality.

[@Bash_Tech_]

Actually pla is Not as Bad as you think. We Build a catamaran that Runs 160km/h and is completely pla. I crashed and it survived. I'm working on the release of the files. Stay tuned 😊