Building a Boom Pole for my Kubota B2910

This time at the Quick Speed Shop I build a custom boom pole for my category 1 3 point hitch boom pole for my Kubota B2910 from materials I had laying around.
Please like, share, and subscribe. I put out new videos every Wednesday and Sunday.
#diy #kubota #tractor

[@morgandollar5806]

CLEVER!!!!!!! You saved enough for a Genny Garage Refrigerator!!! Fun to watch you figure it all out and accomplish the task! NICE JOB!!

[@QuickSpeedShop]

Everything is about saving money for beer!

[@MyLifeThai371]

I see Ford 8N's all over town in the residential neighborhoods with these boom poles on them. I once saw a guy pick up a set of pre-formed 5 step concrete steps that were against his house, because he wanted to build a deck. He estimated those concrete steps weighed 1500 lbs.

[@Raydawg]

That thing is COOOL, and way better then the store bought chinnese one. Another AWESOME build video buddy. Thanks for sharing the video Josh, Have a great rest of the week

[@QuickSpeedShop]

Thanks Ray. Good luck with geocaching.

[@ericcoffedgp40]

Awesome work Josh! Very resourceful! That implement is not only cheaper but it is built better that one purchased from TSC or any other store! Built not bought!

[@QuickSpeedShop]

I just made it so heavy I need another picker to put it on/take it off 😂

[@ericcoffedgp40]

@Quick Speed Shop Haha, the never ending picker madness! 😆

[@waynespyker5731]

I bought a used Oliver boom for my Ford 661 at a farm sale, the most useful accessory I had. It was constructed like your diagram except a plate w/chain eyelet replaced the ring. A 5/16 end plate on the centerline finished the boom and stringer rod welding with a slot into the round hole above formed the chain eyelet. The hole could be large for the chain hooks to clear with a link slot on the bottom. The hole diameter cleared the link's width while the slot cleared the link's thickness. A chain with one hook removed inserted through the hole provided unlimited link by link adjustments. Using a second chain with end hooks provided additional load positioning or a smaller link thickness for more options.

[@QuickSpeedShop]

Super handy. I can't wait to use this one.

[@mark98070]

Get a set of Pat's cat 1 quick hitch for your Kubota. Makes for struggle free connect- ing of your implements.

[@QuickSpeedShop]

I've seen those quick hitches, but everything is expensive. I am going to build a SSQA for the front so I can change between the bucket and forks.

[@deepbludude4697]

I like your design better then the one I cobbled together for my 66 MF203 I spent more time grinding all the rust so I could weld then actual welding itself. Good job!

[@QuickSpeedShop]

Hours spent grinding is half the fun.

[@cogentdynamics]

Seems too heavy! Cool. I have a Carolina engine hoist I don’t need since getting the pallet forks. I wonder if I could cobble it together keeping the hydraulic cylinder.

[@QuickSpeedShop]

I'm sure you could

[@shawnwright2356]

I was looking for a mower deck. Couldn’t find any.

[@QuickSpeedShop]

I sold mine in a day so I guess they are desirable even though the tractor is 20 years old.

[@shawnwright2356]

@@QuickSpeedShop I ended up paying the big bucks for a new one. The used ones I found were junk or 2000 miles away.

[@RMS-gl6wl]

You would have been better off with a jib for the front end.

[@QuickSpeedShop]

I wanted to build a boom pole for the rear. The front has a loader.

[@thomasfaucette1660]

your idea of heavy may not be heavy