Building a Guitar Workpiece Holder || Spray Booth Part 2

[@wolfd91]

the effort alone in these video's deserve more than 1,4k views, great job!

[@AugmentGuitars]

Thank you!! A lot of hard work went into it, worth it though! 😊

[@roguecthulhu6002]

got some great ideas from this and from part 1

[@mikeb792]

Very nice video, sir. New sub here. Love the content. Just to note, when/if welding: The conduit is (usually)galvanized which means that if inhaled can be toxic. Also, the gas pipe fittings can be of a dissimilar metal so "just welding" may be nearly impossible for most, depending on the carbon content.

[@AugmentGuitars]

Good to know, thanks for the heads up! Another selling point for the Maker Pipe fittings then lol!

[@mikeb792]

@@AugmentGuitars Yep. Thanks again for sharing this process. I learned a ton.

[@ScheltemaBoutiqueGuitars]

This is my next project. Very well presented thank you.

[@AugmentGuitars]

If you need any help feel free to reach out! 🤘🏻

[@brianmcclintock1194]

fantastic build I fell on these videos by chance whilst researching booths but love the content . can you clarify where you vent the extracted air to ? do it simply cycle through the two filters and back into the basement area , or do you duct it to a ventilation route out the building . many thanks !!

[@AugmentGuitars]

Thank you! I have the exhaust set up to go through a 6" or 8" flexible duct pipe that then goes to a flange with a damper outside my house. When using the booth, I open one of the windows in the basement (far from the booth) to allow clean air while the fumes exhaust. Hope that helps! :)

[@brianmcclintock1194]

@@AugmentGuitars many thanks for the reply 👍👍👍

[@Aeidotronics]

Welcome back.

[@AugmentGuitars]

Glad to be back! It’s been a while. 😅

[@deandee8082]

use sealed bearing top and bottom of your lazy Susan so its very easy to spin, you can thank me later

[@AugmentGuitars]

I almost went this route!

[@AJbassist]

it turned out look close to SpinTwist Paint Rig

[@AugmentGuitars]

Just checked that out, pretty similar! Glad this jig is a better cost alternative to that one. Thanks for watching. 🤘🏻