"Built" Ford Turbo 2.3L Engine Tear Down, What a Surprise, Facebook Marketplace Find.

I bought a built turbo 2.3 short block and today I decided to tear it down and find out if I got a good deal or not.
#turbo
#fordranger
#teardown
best car hack, old mechanic trick, stuck oxygen sensor , bad oxygen sensor , bad o2 sensor, o2 sensor replacement , life hack, cheap fix, stuck bolt, stuck stud, stuck screw, stuck fastener, fatal flaw, Ford 5.4 3v, Chevy LS, Honda, Toyota, Lexus, mustang, coyote, ranger, Ecoboost, hemi, brilliant idea, tips and tricks, angry customer back, how to test o2 sensor how to test jeep oxygen sensor, how to test jeep o2 sensor jeep, o2 sensor, ranger o2 sensor bad ranger o2 sensor p0171
tesla fsd software, after learning this secret, never change another sensor, better gas mileage, just rolled in. old mechanic taught me this trick, best mpg, best gas mileage.
7500obo, 30mpg, 35mpg, 40mpg, better mpg, 50mpg, 40mpg carburetor.
rough car idle
rough idle bogging down
fix rough idle
engine hesitation
check engine
idle fix
common engine problems
engine idle problems
engine surging
top 5 problems
engine misfire
hard start
no start
engine burns oil
sluggish
icm problems
power loss
idle issues
engine smoking
horrible fuel economy
high idle
low idle
mass air problem
vacuum leak
bucking while accelerating
bad oxygen sensor
symptoms of a bad oxygen sensor
02 sensor symptoms
signs of a bad oxygen sensor
o2 sensor
oxygen sensor test
how to find oxygen sensor
oxygen sensor location
bad o2 sensor symptoms
air fuel ratio sensor
how to check bad oxygen sensor
bad oxygen sensor
oxygen sensor problems
o2 sensor test
the baddest ls engine ever
the baddest billet LS engine
extractor de mandíbula
no oil, no escape
massive oil leak

[@anthonysaoulidis6340]

Has some great parts in that short block

[@thereluctantgearhead4544]

Thats a nice unit. Should hold some power. Those pistons are big money. Rods too.

[@anthonysaoulidis6340]

Looks like CP pistons meant for an Esslinger Aluminum Head.

[@everydayirace]

That short block did have esslinger head on it is what I was told.

[@anthonysaoulidis6340]

@@everydayirace they are the same pistons & rods that I run on my 2.3T. Making 420HP to the wheels with those parts. Quality items.

[@FernandoLopez-rt6mx]

Nice find man

[@everydayirace]

I think so too, even with bad bearings.

[@401kdad5]

This is old but throw away that HV oil pump and use factory

[@JohnJames.]

How important is the oil sprocket to be in time on a 94 2.3? How would i know if i fudged up

[@c.j.crafts9421]

Great video. What do you think caused the bearing wear?

[@everydayirace]

Thanks, but I honestly don't know, rod caps were mismatched on rods 1 and 4, and there was a fairly fresh high volume oil pump installed, and then there was an assembly lube 😆, I can speculate but it would be nothing but guessing.

[@Fredness2300]

What happened with the T1/T4 cap issue on the rods?

[@everydayirace]

I don't know for sure, probably got switched over by an accident after the engine spun bearings if I had to guess.

[@nerophine]

fun

[@everydayirace]

It was, have to find few more.