Whirlpool Cabrio Maytag Bravos Washer Bearing Removal and Install - Tips & Tricksll Tips and Tricks

[@arthurfricchione8119]

I just got rid of mine. 5 yrs old and a piece of junk. My wife hated it. Sounded terrible and the noise was unreal. Bought a speed queen all mechanical all metal gears and transmission. NO PLASTIC NO ELECTRONICS. GOOD LUCK

[@bundysgarage]

Yeah my wife hate it too. She says it does not clean as well as the one we got rid of. We were all excited to get it 8 years ago and after a week of using the new one, we wish we hadn't sold our old ones. If I can get another 5 years from it I'll be happy.

[@5jjt]

If you take a small metal pick, you can remove the bearing's rubber seal and pack the bearing with some better grease.

[@bundysgarage]

Thx for the tip!

[@claytonjbeckiii3429]

I'm sure this will be helpful to many. I had to replace the bearing in my 90's era Neptune (the one that sank Maytag). There was only one guy on the Internet helping people. He invented a puller and even rented it out for a reasonable price. Took whaling on it for an hour with a 5 lb sledge but I got it. Maytag repair wanted $600 to repair, I did it for about 10% of that and had the satisfaction. I hope your video will help many, again thanks for putting this ans your other helpful videos out! :-)

[@doctorfeinstone6524]

If you're referring to the tony tool, it's price is anything but reasonable

[@WilliamHollinger2019]

It have been happened to my and we are in progress of repairing.

[@arthurfricchione8119]

Been there done that she would not let me fix it. Had to send the parts back. Have to keep her happy. GOOD LUCK

[@bundysgarage]

Thanks. I know the struggle brother. Happy Wife, Happy Life!

[@israelmendez2259]

It was showing sd on my Whirlpool Cabrio so I replaced the bearings and a new shaft now sd code is gone but now showing code ul could it be the suspension rods?

[@WilliamHollinger2019]

You could over fill your washer with load if it still have the ul then the suspension then.

[@robertscott8227]

i bought my parts from an ebay site . i bought tools and bearing shaft kit for 129.00 they come all together as one package . i have a suggestion on cleaning out bearing surfaces on the the washer side use brake clearer but remember this stuff is flammable so use adequate ventilation . i also used a small amount of Loctite on the nut that is on the bottom lower nut on the shaft , it prob isn't a big deal but the nut on my washer was loose ,this may be part of the seal failure issue . its not a real complicated repair but takes a little time .

[@bundysgarage]

Good info. Check this out: kzbin.info/www/bejne/fpnOm2uwhtJ_bKs

[@ScantPear]

Cabrio not cubreo

[@andrewdugan6705]

Pronounced CAB-reo, not kuh-BRI-o Sorry, but this drives me crazy. Good informative video though. Thanks.

[@tellsthetruth894]

This video is unnecessary.