C7 Corvette Seat Removal

C7 Corvette Seat Removal. This video demonstrates step-by-step procedures on removing the seats in a C7 Corvette. Video demonstrated by "Corvette Hop" a corvette enthusiast.

[@eparker99a]

Swapped out GT/Comp seats yesterday. Your video was very helpful! Thank you!!

[@SharpByCoop]

Thank you for this. Very clear and safe. I want to add 2" spacers to my driver's seat and this is going to get me there. (Yes, I will need longer bolts. Check.)

[@roastum1usa206]

Good video once again sir👍

[@rollingtones1]

5:43 Before removing the seat, put a cloth down over the door sill and drape one over the door panel.

[@swagger7]

Great to the point video. This is what KZbin is about...

[@vette5808]

Nice video. I found that pulling the bolt cover forward and lifting the back will keep one from breaking the front plastic cover channel. Any ideas on how someone could put a vibration damper between the seat bracket and body? I'm trying a half inch 3d printed disc.

[@ahmedsti8460]

Is there any airbag sensor popping ?

[@rollingtones1]

That screw takes a 10mm socket or T25 Torx, NOT 1/4”. This is an all-metric car.

[@rollingtones1]

The seat nuts are actually 15mm, not 5/8”.

[@Mark-vc7rm]

Dang when was the last time the vet saw a vacuum cleaner? Lol

[@TheWhatisright]

Ya I know LOL Not much room under the seat to get all the small stuff. It sure needed it.

[@dylanc453]

Any ideas if the motor is bad and the seat won't move forward?? Just trying to remove them and can't get to the rear bolts

[@TheWhatisright]

Check the wire connection points. Sometime they come loose. Otherwise, use a small pneumatic wrench that may fit into the slot.

[@dancharron7098]

LoL you would have better tools if you used Metric tools as this car is built with all Metric tools.... the OLD SAE system is for cars and trucks from before 2000... after 2000 they become obsolete. just know that you are no longer in the old world and you need to move into the future.

[@TheWhatisright]

Thank you and very good point.