Nice work Derick. That shifter dropping into the hole was pretty satisfying :)
@King_Arthur50510 күн бұрын
Nice video man very informational. I’m getting ready for a manual swop on my 2010 Camaro ss I’m wondering if you got a part number for the harness and do I have to do the computer programming after the harness clutch pedal and trans are swapped?
@Gunrcowan3 күн бұрын
Working doing this to a 2011 Silverado but just curious on the PCM side did you use the same PCM and just swap it to manual in the Tune??
@jakemalky81883 жыл бұрын
Good stuff buddy!! Love it
@Gaskinsmotorsports3 жыл бұрын
I am so happy with the turnout! Better than expected
@chiefm99302 жыл бұрын
Camaro is so clean 💙 the wrap looks good👍🏽
@buddyrebel_Garcia3 жыл бұрын
Did you lose weight? I just finished watching your GTO build videos and came to this one. Saw skinny guy, said that aint the same guy.
@Gaskinsmotorsports3 жыл бұрын
Yeap it’s me. I have lost 150 lbs and feel so much better! Thank you for watching!
@buddyrebel_Garcia3 жыл бұрын
@@Gaskinsmotorsports that’s great man!! That’s a lot of weight congrats!
@Gaskinsmotorsports3 жыл бұрын
@@buddyrebel_Garcia thank you!
@Danslife692 жыл бұрын
if you are going from manual to automatic would you still need to get a modified harness or could you just use a auto harness?
@Gaskinsmotorsports2 жыл бұрын
You can make the auto harness work by putting your canbus wires together. I just wanted it to look factory and not have any problems.
@bumblbeegaming2 жыл бұрын
Wondering if you can help me man? I have a 2010 camaro ss auto and swapping to manual. Your videos were killer and I have everything done and ready to go. I’m in a situation with the wiring for the clutch pedal sensor? Need help on what to wire to. The connectors are different on the 2013 and up and I’m stuck. Please get back ASAP
@bumblbeegaming2 жыл бұрын
Would it work to bypass the dash harness by tapping into 26,42, and 54 pins ( the wires for clutch pedal) before the ecu?
@connormckenzie5648 Жыл бұрын
My brake pedal only has 3 wires (2011 V6 Camaro) What should I do?
@Gaskinsmotorsports Жыл бұрын
I responded to this same comment. Look through my comments and you will find the answer
@Kale8643 жыл бұрын
I honestly think I might do the same down the line whenever My 6l80 goes out
@brandonnowak6270 Жыл бұрын
Is it easier to program with the auto engine harness in or swap to the manual then use the hp tuners?
@Gaskinsmotorsports Жыл бұрын
I would swap in a manual harness. It’s worth the money and helps clean things up.
@brandonnowak6270 Жыл бұрын
@@Gaskinsmotorsports I have one. Thanks.
@brandonnowak6270 Жыл бұрын
But I need to use the 6 pin for the cam sensor. I tried slowing down the video. I can’t see what 3 wires you used