➡️ Turbosmart Wastegate Actuator: carmaspeed.com/products/turbo... ➡️ Tune by Alan from Edge: edgeautosport.com/edge-autosp... ⭐️ Amazon list of tools & necessities -bit.ly/toolsfromcam Chapters:
Пікірлер: 51
@electricdoor Жыл бұрын
This is absolutely the best RS WGA install video on YT, but it does make the removal of that bottom heat shield bolt look easy. It's the hardest part of this job IMO. I spent an hour cramming my hands between the turbo oil lines & the turbo, using a T30, (which was too big) a T25 (which was too small) and a 4mm allen, (which fit but I couldn't hold onto it well enough to turn) and eventually gave up and did the whole job with the heat shield bent back. It was absolutely a nightmare but it IS possible to do with the bottom bolt still on, especially if you unbolt the PMM like Cameron does. Reinstalling the clip on the clevis is also kind of a pain. Either tie elastic string to it (you can yoink elastic off the clip when it's installed) or get a magnet in there if you can fit it and push it on as hard as you can with your fingers so it "sticks". Then, get something flat (like that magnet) to push it down more, THEN get a flat head screwdriver and push in those grooves in the shoulders of the clip one at a time. Job done. The howling/singing noise you hear at 16:01 is the car needing a sound suppression chamber. That install also sucks almost as much as this one, (massive snap ring in a weird spot) but the part is cheap and it does fix the issue. DO NOT go WOT with this thing on without a tune. You WILL overboost and kill the engine. My base tune also needed E85 and my aux injectors hooked up so on the way to fill up I tempted fate and found I was getting 25PSI at 70% throttle in normal mode.
@joeyhilton76 ай бұрын
What does wot mean, just got a wga for my stock focus rs, just doing some research to make sure im not gonna blow it up
@xiDynazty6 ай бұрын
T27?
@jesuscarrillo434416 күн бұрын
@@joeyhilton7 Wide Open Throttle = flooring it
@jakegray121 Жыл бұрын
I'm just waiting on my ETS Intercooler to install this and I've been dreading it. This should help a ton. Perfect timing my man!!
@mdanielsolis4 ай бұрын
Did you ever install both parts and feel a difference in tune after
@KrismanX Жыл бұрын
So glad this is here I think I need to install one on mine bc I’ve got some boost leak under heavy throttle and it could very well be the stock actuator!!
@the_rafa039810 ай бұрын
Loved your video sir thanks for documenting all of it!
@tone.impastato Жыл бұрын
Always a good day when Cameron Uploads😊
@jaybones614 Жыл бұрын
Before anyone tries to test their wastegate with air make sure you dial down the pressure. They aren't designed for high shop pressure. Especially a used stock one.
@allendaniels37688 ай бұрын
Could you use a bike pump?
@jaybones6148 ай бұрын
@@allendaniels3768 yes you should be able to depending on the pump
@Mrennnn Жыл бұрын
i wanna get this for my ST i just don’t wanna end up having to pull the turbo and was waiting for a vid like this thanks man
@dylans3553 Жыл бұрын
just dynod with alan hes the man
@MarkFritscher Жыл бұрын
this was one of my first mods based on the forums and such an improvement over stock. I understand from a business perspective but at the same time if I was you I would sell the STI or my plasma before letting the RS go. Everyone who sells their RS always talks about how it was a huge mistake. RS's rip so many fast cars, especially on a non prepped surface. Think twice Cam!
@BlueSkyCrystals Жыл бұрын
A number of RS owners returned to the RS after selling their previous one for something more expensive.
@jacobMMotorsport Жыл бұрын
Homie was having too much fun with the air compressor
@Colt-yc2ct8 ай бұрын
Any advice on removing the wastegate clip? I've been following the videos method but haven't had success.
@channningmoua44835 ай бұрын
which wga should you go with? 12lbs or 14lbs. and what is the difference that those spring rates offer. thankss
@nzurmytouch Жыл бұрын
@Cameron So, I got a wild rattling noise coming from my stock turbo ('16 FoST). I' ve been looking some stuff online to see what I can do. Some sites note that the Wastegate actuator, pivot, and flapper can't be replaced and requires a new turbo. However in this video essentially replacing what on my car is already faulty and has play which is causing some rattling. Will doing this install on my ST be fine or is a new turbo truly on my only option? This is the title of a YT video with a very similar scenario as my FoST; "Ford Ecoboost Cold Startup Turbo Rattle Explained" I am looking to replace with a new turbo unless I do have options.
@jesuscarrillo434416 күн бұрын
Replace the turbo. I had the same issue. I got one on fb market place for $120. You can also bend the waste gate back so that it actually does close.
@edwinblanco1789 Жыл бұрын
What happen with Randal ?
@tarelmorton2432 Жыл бұрын
Yo bro, what’s good? I have a Focus St and I’m trying to get it tuned. I’m out of NY do you have any recommendations?
@CameronAlford Жыл бұрын
Alan!!
@UrW0rstNighmare Жыл бұрын
Is there a reason you preloaded it to 5 mms? Is that is what recommended? Also is this a 7psi or 12 psi actuator?
@CameronAlford Жыл бұрын
thats the factory spec for stock turbo.
@micho_3715 Жыл бұрын
Ayyy good stuff getting the turbo coolant fitting clip off without mangling it up. If you ever have to remove those coolant lines again it would be a good idea to replace the fitting. They got a seal on the inside that can get brittle and flat.
@joegouveia46354 ай бұрын
You are so good at doing this stuff,I have a 2018 rs Le I have 13,000 miles on it but actually I have 8,000 on the engine cause I bought a lemon through online can't think of the name right now but it's the red one and right when I got it I had to spend 3,140.00 I had all plans for this car and blow off valve and waiste gate but I just can barely afford to make payments and the engine went a month later thank God I had ins that Ford had to put a new engine please help I want my car to be like yours
@chrisvega3792 Жыл бұрын
You forgot the light in the turbo
@moereefer Жыл бұрын
I’m interested in the car
@dasilvacarvalhocarlos2485 Жыл бұрын
Yes👍👍👌👌
@BenTroxell Жыл бұрын
Feel like I’m at the dentist 😂
@jasondesouza2297 Жыл бұрын
Cant buy any stickers on your site? Wanna rep Carmaspeed with my ST!!!
@jasondesouza2297 Жыл бұрын
Carmaspeed all the way in Canada!
@jessebudelman Жыл бұрын
Need some hood struts my guy.
@michaelsantiago7093 Жыл бұрын
Does the actuator cause the flutter sound??
@abelhernandez316 Жыл бұрын
No it's the intake that makes that sound
@VexyST3 Жыл бұрын
Install a dv+ recirc, should bring that noise out way more too
@akeemcammock1803 Жыл бұрын
does the rs need a catch can too?
@Prolly_tyler Жыл бұрын
Most definitely!!!
@jasperbryce1577 Жыл бұрын
Every vehicle should have one
@Prolly_tyler Жыл бұрын
@@jasperbryce1577 not necessarily 🤔
@Mpostor Жыл бұрын
Any direct injection engine will benefit from one.
@jasperbryce1577 Жыл бұрын
@@Prolly_tyler yes necessarily
@Prolly_tyler Жыл бұрын
Gonna be sad to see it go
@guccitate Жыл бұрын
Not the most used tool, but get yourself an e clip tool!
@warriormonx6 ай бұрын
You MUST get a safe tune after you install. Send it without one and you will likely overboost and grenade your shit