Can’t believe this happened | 1998 Dodge Ram 4x4 transmission removal

[@jmacscrewg564]

No matter what Ray always gets the job done

[@johnflanders6808]

Nice job. Thank you.

[@builtbyray729]

@@johnflanders6808 you welcome thanks for watching stay tuned!!!

[@Freedom_Rider915]

Thanks, very helpful but some advice on the upper bolts would have been helpful. Also, I have watched a few videos on this, and in each one the transfer case just slides out. I didn’t find that to be true with me. It took us 4 hours just to separate the transfer case from the transmission. Still aren’t sure what the problem was, maybe the mechanics lol. You posted this about 6 months ago. I doubt that you will see it. Thanks

[@builtbyray729]

It should slide right apart as long as all the bolts are removed I had a few times when I forgot or didn't see a bolt and it gave me hell 😤 thanks for watching feel free to ask any questions I'll help to the best of my knowledge stay tuned!!!

[@michaeldoef198]

I am doing that on my 2004 dodge 4x4 on the top bolts I use a couple extensions and do them from behind

[@builtbyray729]

Them extensions are the key to getting the bolts out 👍🏽 thanks for watching stay tuned!!!

[@jimmymays-s1r]

What should a basic cost be for all the work you just did?

[@builtbyray729]

I would say between $800 and $1500 on the labor

[@jimmymays-s1r]

Thanks

[@builtbyray729]

@@jimmymays-s1r you welcome

[@homeroaguilar6163]

Hey brother, I have a question for you. Do you know if those bell housing numbers 064-9 have to be the same on the new or used transmission? I wanna replace mine with a used one, but I got some people saying it has to be the same, and some people said not, so I'm confused about it, thanks for the whole information you brought for everybody

[@builtbyray729]

@@homeroaguilar6163 hey just saw your message I’m not to sure on that info if you could take your old one and match it up with the used one your looking to get to be sure if not I would call a local dealership and ask someone in the parts department

[@kaydenkayden8610]

3:40 what’s the seal or gasket for that side of the driveshaft?

[@builtbyray729]

@kayden kayden it’s the tail shaft gasket on transfer case

[@thatguyty89]

better audio setup and camera will definitely get you more views. also consider a brief intro

[@builtbyray729]

Definitely working on it thanks for the feedback it will help me grow stay tuned !!!

[@sickduck66]

Bad ass thank you boss!! I'm literally looking at buying a 98 Ram 1500 tomorrow.. engine runs good and goes into reverse no problem just has a hard time engaging to first. How much is a tranny going to run me

[@builtbyray729]

No to familiar with Dodge parts but the one I was swapping out here was replaced with a used one from a auto wrecking yard for $600 just to give you an idea not sure if that was a good deal or not I’m more of a Chevy guy

[@sickduck66]

@@builtbyray729 600 for a functional transmission is a steal!@ ima have to look at my local yard. I'm prepared to spend around 3k on a new one

[@GodsSon_till_theEnd]

What was that particular transmission model number

[@builtbyray729]

@@GodsSon_till_theEnd 46RE was on the the transmission

[@sickduck66]

​@builtbyray729 hay bro when installing this replacement 46re did you need any new gaskets or seals?