CBR600F4i Engine removal part 2

[@jayvee1901]

Thank you so much for this and the other video!! We're working on our FSAE race car with this engine and this was so useful in figuring out all the cooling hoses. Thank you again! From all our team South bank racing from London

[@jeffhumes]

would love to see the race car!

[@JD-lz7gh]

Well needed about to attempt a engine swap by myself for the first time this week

[@jeffhumes]

let me know if you run into issues

[@willstan3959]

Very good video makes it so easy I’m used to air cooled engines but this is not that much harder

[@jeffhumes]

Thank you much for watching!

[@MiamisFinestUnseen]

Bravo kind sir, excellent video!

[@jeffhumes]

Thank you for watching!

[@MarcoantoniofilhoFilho-zp5xx]

N entendo sua língua mais entendo a dinâmica qui vc passa melhor qui vi até hj muito obrigado linda aula aprendi muito

[@jeffhumes]

Thank you very much for watching!

[@182Bassist]

I stripped the motor mount threads where you have the frame slider . Can I retap it by removing the gas tank and retapping from the inside ? Worse case scenario I’m have to take the motor mount out . Please get back to me thank you

[@jeffhumes]

Yes, you should be able to tap it just fine, as long as you have a tap that is long enough

[@CBRiderMT]

How come your bike in such almost new condition?? )))

[@jeffhumes]

bike had been stripped and repainted previously

[@akgagh5621]

عمل روعه

[@jeffhumes]

Thank you very much! Thank you for watching!

[@akgagh5621]

حبيبي أنا من العراق كم يحتاج دبل صدمه امامي من هايدروليك

[@jeffhumes]

@@akgagh5621 Some forks require a set amount of fluid, and some require you to set the fluid to a specific measurement. F4i forks in general require the latter, a specific measurement. I do not have a video yet for this but will have one soon. For the bike in these videos, the measurement is 116mm.

[@akgagh5621]

شكرًا اخي

[@jeffhumes]

@@akgagh5621 You are most welcome!

[@dillin2962]

are the oil pan bolts M6?

[@jeffhumes]

Are you asking about the drain plug, or the bolts that hold the pan to the engine?