cdi ea faults

[@paulmusther4219]

Ace .allways willing to learn new things. Thanks very much .

[@gason6175]

Superb Geoffrey you are saving loads of boilers , Keep them coming

[@leecrook6918]

Great , thanks - provided some specific starting points for the engineer to look at next week on a WB 30cdi classic with intermittent but now increasingly frequent EA fault ....In mid December the condensate siphon trap was blocked with tiny metallic debris, it was cleaned out and had a full service .... burner was a bit mucky but everything else looked good. But just 3 days later EA fault reappeared. Since then, it has done it about half a dozen times and reset after several attempts ....until today. Checked siphon trap , and found it full of the same debris again. Flushed it out. Boiler fired up after initial commissioning cycle. 🤔 I want to find out what is causing the siphon trap debris build up within just 6 weeks? Doesn’t seem right !!

[@mikesodion3671]

I had this issue. I cleaned the heat exchanger and it was sorted

[@tswgas5553]

Clever idea of using graphite with a pencil to stop bearing plate sticking

[@GHEBIANDGAYAR]

Brilliant sir very professional

[@arunask3689]

Hi, what possible issues could be, boiler was off for a while and now getting EA error code when open hot waterin the bath. Other taps seems OK. Looks like it's struggle to heat up water.

[@alistairnewton8898]

Thanks for this upload much appreciated , :)

[@oiltec3369]

Top Class

[@umarhussain8543]

Geoffrey why did you go over the bearing plate with a pencil?

[@bradleyfallon4297]

stops the bearing plate sticking to the metal.

[@thegasmanajay]

Graphite in the pencil acts as a lubricant between the rubber flap and round metal frame of the plate - old skool

[@1joelsmus]

Genius!!

[@MrHukd]

Whats with the silly music😆

[@happyslapper07]

Just mute your phone simple!