Chain Sharpening (consumer)

[@rodcollman6849]

I have been using these roller guides by Husqvarna for 3 years they are well worth using all the time the method of holding the file is not governed by pushing the file it will go through the process without being pushed you just let the file run natural against the tooth

[@2nostromo]

How many strokes usually?

[@Drottninggatan2017]

@@2nostromo You can count on 4 strokes on each tooth. At least 2 strokes to get the filing going and then one or two more to get underneath that chrome plating. Actually you should not use a file handle like in this video but a round handle, and then rotate the file, as he did in the video, but keep rotating it, round and around.

[@ksk5517]

Girls hate when there are no periods.

[@KenzoCodm]

Good, I would like to ask, I want to order the same set as you are using, will it fit the husqarna 120 mark ii

[@TheCrusades1099]

Thank you!

[@NODARKNESSNOLIGHT]

The depth file part is confusing, so I place the back of the gauge on the tooth behind it?

[@cjack121]

You need a whole different kit for each chain size, not just the file?

[@sethjanisse4889]

I just couldn’t see what he was doing close up.

[@joshclouse6327]

Not a great view from camera angles. Hard to learn from this

[@greenacresfarmsgreen4438]

this guy dont know what he doing file not even in the tooth

[@mrscuba1693]

not a good video on sharping

[@japples6852]

Not a good spelling of sharpening.