543xp build vid

[@ragercrepair9301]

Man that's gonna be sweet when you're done! Ready for a bench run!

[@tedneitzel]

Good stuff!

[@tomv7552]

I wonder if they use the cylinders that aren’t up to spec in the lower quality clone saws.

[@old1234]

Thx for the video. Did you end up using the neotec coil and flywheel on Doug's neotec 843? You mentioned you might need to do that if timing was off. I don't think you ever said if the timing was ok or not on that neotec. I really enjoy your vids!

[@jamiewykes8585]

I'm curious about this as well

[@CharlesBrisco]

I.used neotec stuff did use oem thrust washers an wrist pin an barring tho

[@bennyblanko3]

@@CharlesBrisco Dub's ported 543 clone just blew up because one of those thrust washers failed, on a neo version saw.

[@old1234]

Ya the washers are a known problem. CB used Husqvarna washers on his neotec build

[@Doc-Cole_Trickle-of-Chainsaws]

👍🆙CB