Ford Mondeo MK3 ST220 Vactan Rust Converter treatment complete rear end

[@aurelienz1422]

Hello Chazz Coombes. I just want to thank you from France. I could do a lot of reparations on my 2005 Mondeo 2.2 TDCI titanimun X (ST style); I replace the radiator, driveshafts, front roll bar supports...and your videos were a very good support and helpfull. So thanks a lot, you do a great job under a car, but an another one as much great to filming your job, cut it, and upload it on youtube. The time that i spent under my car let me thinking that Ford do a great car, not so hard to repare,and a solid one which can pass 20 years without rust (for mine) Un très grand merci pour vos vidéos et votre partage! Amicalement Kind regards

[@matthewf4402]

Impressive work, a great foundation for an epic car 👍

[@chucky2316]

Clean mondeo chazz

[@ChazzCoombes]

Cheers mate, alot of work gone into this now, lol.

[@chucky2316]

@@ChazzCoombes I was keeping my fingers crossed for you that a hole didn't suddenly appear

[@dalethomas360]

Top work , Buddy 👍 Got my subframe back on and car rolling again after doing mine. Found the worst bit was under the mounts for the trailing arms. Can I advise that you do a test piece with the Etch Primer before fully applying. I was using Halfords Etch Primer directly over the Vactan and had no issues. I then ran out of this so ordered a few tins of U-Pol Etch Primer, as its good stuff. I used this on the other side of the car the following week. When I went back at a later stage to apply paint, I found that the U-Pol had reacted, so had to rub it back down. Keep the vids coming and looking forward to the updates 👍

[@ΒασιληςΜαρκουλιδακης]

Special

[@mondeost220restorations9]

Top work Chazz! I know how you feel but keep going. What primer/top coat you gunna use? Id recommend cavity waxing whn you're done painting 👍