Is it worth it? Aisen AMR500 supercharger will it pick up? or is it just snake oil follow along with me and see i think you will be surprised.
Пікірлер: 31
@T_Burd_759 ай бұрын
Greetings from WV! I'm wizard93 on the GMF. I noticed you mentioned Potter, I've met him a few times at the meets. I've had the same idea putting one of these superchargers on my red 1994 Metro. I'm wanting to try to get this to work on a stock engine, since the stock injector is also used on the G13 engines and I think the G16 engine, so I'm guessing as long as the fuel pump is healthy, there shouldn't be an issue with fuel starvation. I'm also wanting to mount the supercharger on a modified A/C bracket and use the A/C pulley on the crank, and find a hat that will fit on top of the stock throttle body. I'm also wanting to use an intercooler and set the boost to no more than 10-12 PSI. Just something that will help her pull the WV hills on the interstate, nothing too rowdy.
@HotRodGuyGarage9 ай бұрын
You will need a custom pulley made for the supercharger the supplied pulley make way to much boost for a reasonable setup there is lots of drive ratio calculators for superchargers
@T_Burd_759 ай бұрын
I appreciate the info, thanks!@@HotRodGuyGarage
@ryantrejo7996 Жыл бұрын
Sweet
@stavrosferedinos5849 ай бұрын
Just found gold yesss
@markusa11216 ай бұрын
Episode 12 🎉 kickin butt 👍
@crazyasspotter Жыл бұрын
Still considering this for my 4dr automatic project that will be happening sometime.
@timothykeith13676 ай бұрын
1,475 pounds? That's very good! If you can make a lift-off fiberglass hood and rear hatch, I think the weight can be under 1,400. 1,475 lb is pretty light. Lexan or plexiglass sideglass is doable.
@HotRodGuyGarage6 ай бұрын
There's always further to go later!
@jimmywilson1388 Жыл бұрын
This is awesome man… I can’t wait to see what’s coming next…😁 I looked that super charger up and it said like 1.6 liter to 2.0 liter. So I guess it’s to small for the 3.0 danger ranger…😕
@HotRodGuyGarage Жыл бұрын
For a cheap setup look at the Eaton m90 that is found on mid 90's-2008 gm 3800v6's harder to adapt but will work on 3-5L engines
@jackkonnof4106 Жыл бұрын
I wonder if a slightly larger supercharger underdriven would do the same without spitting oil.
@HotRodGuyGarage Жыл бұрын
Yes a larger pulley will run the supercharger slower
@biggscasey80 Жыл бұрын
I like it !!!!
@chairmanofwhat Жыл бұрын
I love it.
@jackkonnof4106 Жыл бұрын
I am getting ready to order my amr 500 and wondered if I can do this in stages. In your opinion could I run the blower with the stock throttle body? Is there enough potential for a stock injector to put out enough fuel. to stuff the extra air through without it running to lean? Or with your experience would I have to underdrive a little for it to keep up on the fuel end.If so any guesses on % of underdriven. Or is it a nogo until i do stand alone ecm for timing changes for boost? And a larger throttle body..Or am I doing things in the wrong order? I really appreciate how fast you have always responded and your willingness to help others. Thank you!!
@HotRodGuyGarage Жыл бұрын
I would definitely underdrive it, a old school fmu would help with fueling with the stock TBI I'd have to run the math later to figure out the percentage to underdrive it. Definitely add a wideband so you can have a idea if it's rich or lean
@jackkonnof4106 Жыл бұрын
I will get one. Remembering how many pistons I lost to melt down in my dirt bike days guessing jet sizes when making changes that's a wise suggestion.@@HotRodGuyGarage
@JC-ly8pzАй бұрын
what was the size or model of the procharger hat? Was it a direct fit over the TB?
@JC-ly8pzАй бұрын
Now that I think about it, its probably a turbo hat that fits your holly sniper you have installed.
@HotRodGuyGarageАй бұрын
Correct, there is nothing available that will fit the OEM TBI but one can be custom made with some effort
@1MADZ11 ай бұрын
Boost controller
@drakeperez1595 Жыл бұрын
How much was the build for the turbo charger
@HotRodGuyGarage Жыл бұрын
Not a whole lot but I have a bunch of parts laying around from past projects
@nightmarejr Жыл бұрын
How are you tuning for fuel? Or are you just sending it
@HotRodGuyGarage Жыл бұрын
It's on a Holley sniper
@leeatterberry1239 Жыл бұрын
I know how to make that thing go faster put on put it on the back of a flatbed pickup truck
@HotRodGuyGarage Жыл бұрын
Lol, different cars for different purposes
@RBoland1979 Жыл бұрын
Where did you get that supercharger?
@HotRodGuyGarage Жыл бұрын
EBay just search amr500
@RBoland1979 Жыл бұрын
Depending on how it works out for you, I may pick one up. Having a review that can be trusted definitely helps.