Check your point of impact...Roger Pace ...The Ancient Shotgunner

[@125saito]

Man Roger these videos of late have taken on a whole new level of informative value. God Bless

[@rogerpace9322]

Thank you...much appreciated!!!

[@frankwebster8365]

Thanks for this amazing info.

[@Badger350]

No nonsense, no fluff. How refreshing!

[@rogerpace9322]

Thank you...very much appreciated ...and thank you for watching !!!

[@JuStIcEcLarK28950321]

Well done Rodger!

[@rogerpace9322]

Thank you...glad you liked it !!!

[@pdb1565]

Thanks Roger very informative 👍🏼

[@rogerpace9322]

Thank you and you are very welcome !!!

[@Jeff-mv4yy]

Roger! You nailed it! The pattern board tells you nothing if you aim like a rifle. The whole idea is to get the gun to shoot where you are looking, and as you have repeated many times, we should be looking at the target and nothing else.

[@rogerpace9322]

Very well said...good on you and thank you for watching !!!

[@michal.abramowicz]

I will do that at Friday! New stock, new glasses!

[@rogerpace9322]

Good on you Let mr know how it goes !!!

[@aeron-mw7ofs]

Cheers Roger 👍👍

[@rogerpace9322]

And to you my friend...stay well !!!

[@timeverett7828]

Good on you!

[@rogerpace9322]

And to you my friend !!!

[@abaker4791]

Good video Roger.

[@rogerpace9322]

Thank you and thanks for watching !!!

[@bluesea3776]

Excellent advise. What brand of ear protection do you use?

[@rogerpace9322]

They put a cotton wad in your ears...then they inject a silicon into the ears...when dry they pull it out...polish and seal it... and they are the perfect shape of your ears. Thanks for watching and stay well !!!

[@marktomarchio4905]

Thanks Roger. Out of interest, what did the beads look like when you looked down the gun? If it's shooting to one side they must have been slightly out of line yeah? Also how much gap (if any) do you see between your beads height wise?

[@rogerpace9322]

Mark i only looked at the target...all 4 shots were to the left...so at least it was consistent...my mid bead covers half of the front bead ...the POI could be lower...but that is as low as the stock will go

[@notar2540]

So if I hear you well, with the wind noise, to shoot higher we elevate the comb and, to shoot lower, we lower it. Is that right ?

[@rogerpace9322]

Yes that is correct...Stay well and thanks for watching !!!

[@frenchyqbec]

Hi Roger, just wondering, why is it better to shot high than in the middle ? Thanks !

[@rogerpace9322]

The common belief is that it is better to shoot higher because the clays are rising...I would prefer my POI to be a bit lower but that is as low as the stock will go !!!

[@frenchyqbec]

@@rogerpace9322 Makes sense, going back to the patten board soon, but this time I will not use the poll to shot, didn.t feel natural anyway... will try the way you showed us... Thanks again, it realy helps !

[@rogerpace9322]

Good on you. Stay well!!!

[@AnthonyNewman-pq3el]

yikes that's miles off ?

[@rogerpace9322]

I did fix it ...and yet before I changed it ...I was shooting reasonable scores !!!