Chevy Cruze master cylinder clutch replaced

[@santoscamacho3361]

Thank you for sharing!..I have the same car and mine just went out on me!..saved me a lot of money!

[@cleberonegociantedaamerica]

You welcome

[@cassiehill6318]

At 3:35 you say to remove the top hose, but you don't show it. I can't figure out how to remove it. Do you just pull it out? Do you need a special tool? Thank you.

[@cleberonegociantedaamerica]

The hose I removed from the master cylinder I use the plier to remove the clamp

[@cassiehill6318]

Oh thank you for the reply! I can't figure out what kind of clamp it is.

[@atrevisi]

Very useful Thanks!!

[@cleberonegociantedaamerica]

You welcome

[@sbonisophakamani6256]

Hi sir I have the same problem and I changed the master cylinder but problem still persist like after replacing master cylinder it will engage first gear then when you try to go faster so that you will engage second gear it just stays on the floor and changing gears when you move slowly it's Diesel 2l Chevy Cruze LS

[@cleberonegociantedaamerica]

I think you have air going to line check if you have leaks on the line

[@sbonisophakamani6256]

@@cleberonegociantedaamerica Ok thanks will check as I just wanted to remove gearbox today but I haven't finished yet to take out the gearbox because the fly wheel was taken to engineering around April so wanted to check even the release bearing

[@sbonisophakamani6256]

@@cleberonegociantedaamerica Hi brother I got the problem it was the release bearing inside the gearbox it was leaking so I replaced it and the car is fine now 🤝🤝

[@Destroydification]

hi, is there a need to bleed the braking system after the operation?

[@cleberonegociantedaamerica]

No Just bleed the clutch system

[@Destroydification]

How can i do that?

[@joshuabarr6511]

​@Destroydification same way as the brakes. Have someone pump the clutch and then hold it, open the bleeder, let air and fluid out, close it and then left off the clutch pedal. Top off master and repeat a few times

[@dmarqueswilliam1131]

How did you get the piece on the clutch pedal off

[@santoscamacho3361]

How I did mine was you pull back the clutch and it disengages from the plastic clip

[@sbonisophakamani6256]

And I did bleed the system sometimes it will clutch after few minutes it doesn't clutch