Chevy Silverado How to Replace Steering Angle Sensor GM Truck or SUV 2007 - 2014

In this video I will replace the steering angle sensor on a 2008 Chevy Silverado. This process will work for most GM truck and SUV's years 2007 - 2014.
Parts:
Steering Angle Sensor: amzn.to/3wblTWs
Tools:
3/8" ratchet Flexhead: amzn.to/3h9zshn
1/4" ratchet Flexhead: amzn.to/3VQGdDA
3/8" Extension Wobble Set: amzn.to/3UGEIqo
15mm Socket 3/8": amzn.to/46ErUYv
10mm Socket 3/8" Deep: amzn.to/436Yu45
13mm Flex Head Ratcheting Wrench: amzn.to/4a5OeLG
15mm Flex Head Ratcheting Wrench: amzn.to/3Qvieta
T25 Torx Socket 1/4" drive: amzn.to/3n7Zbdd
Panel Popper: amzn.to/3Y6WciH
Protective Eye Wear: amzn.to/4cuf6Hn
Disclaimer
---The Friendly Mechanic assumes no liability for property damage or injury incurred as a result of any of the information/Reliance contained in this video. The content of this video is available for informational and educational purposes only. Always seek professional advice from your mechanic who has thoroughly inspected your vehicle and can make suggestions or judgements. Every vehicle is different, no two vehicles are the same and every repair will be different. The Friendly mechanic does not guarantee results or give warranties implied or expressed. The use of PPE (personal protective equipment) is always recommended whenever working on/with cars, vehicles, tools, parts and Chemicals of any kind. I always recommend safe and proper work practices when operating/handling power tools, hand tools, parts, liquids, chemicals, automotive lifting devices, stands, electrical equipment and or any portrayed in this video and shall not be used by untrained persons. Any injury, damage, loss of any kind that may result from improper use is the sole responsibility of the user and not myself/The Friendly Mechanic. Any and all information you use in this video shall be used at your own risk.

[@ricksmash8080]

I think I’ll just remove the dash lights for traction control, abs, and BRAKE 😂 Good video though

[@friendlymechanic9778]

😂 I know right.

[@elliotcaldwell9670]

My 2012 doesn’t even have the bracket with the t25s in it.

[@alexescobar5707]

Do you have to relearn the sensor? If so how you do it without scanner?

[@Whopper9000]

I think so, just go to an allignment shop and ask them to relearn it it should be pretty cheap if the will