@billdlv Hey Bill, I was using a slightly used 60 AMP. tip, Running at 60 IPM. The edge was pretty good but may have been a little more square at 45 to 50 IPM, more so on the smaller circles, I was turning these in a friction drive set up so it was good enough for how many I needed to crank out!
@KeithFenner13 жыл бұрын
@Steffan97140 I'm using Thermal Dynamics and the torch size is a SL60, giving me a range between 20 to 60 AMPS...
@KeithFenner13 жыл бұрын
@TorqueRider2000 Thanks for the comment, on that, i'll keep it in mind, incase i have to streach out my supply...
@KeithFenner13 жыл бұрын
@TorqueRider2000 I was doing fine, bill was the one using up the consumables at a greater rate than he thought he should be. I was just ignorant of greater consumtion at closer tolerences. I like when I learn something new!
@KeithFenner13 жыл бұрын
@billdlv I've been pretty happy with tip life, you got air dryer hooked up, on yours? I was piercing at .170" and cutting at .130". My thoughts on closing down the gap is because the contact tip, adds a certain distance, between the orfice tip and part when scensing height. From all my manual exp. tells me you get sharper crisp cut closer...
@paulduffey79758 жыл бұрын
The view from under the plate? Pure genius. I'm trying to figure out how to use the plate with holes as a grill for my car. Thank you.
@billdlv13 жыл бұрын
@kef791 yeah we have a good refrigeration dryer on our air. I think it has to do with my inexperience with getting the cut settings. We're making a lot of test runs and pierces.
@BruceBoschek12 жыл бұрын
Hope you saved those cutouts to use as air intake grills for the next air compressors.
@studleylee13 жыл бұрын
Put some long thread-stock/nuts/ and washers through the left over plates and make a stock shelf out of them.
@KeithFenner13 жыл бұрын
@studleylee Almost looks like a wine rack :D
@billdlv13 жыл бұрын
The plasma cnc seems to be running smoothly and your downdraft / water table are working great. What cut parameters are you running on the 1/4 AL? Ours is working again and I'm working on dialing it in. Thnx Keith
@nder1234513 жыл бұрын
wow that really does look like a invaluable tool
@97Leydens11 жыл бұрын
Well that definitely beats the old hand held jig saw method lol
@billdlv13 жыл бұрын
@Keith yeah the tips wear out kinda fast I've found on ours. What was your Z height?
@Steffan9714013 жыл бұрын
I am looking into a plasmacam in the near future and am curious what brand torch do you use and what size is it?