Calling all BAKER Gearheads! Class 14 will show you how to properly adjust your primary chain. For any further questions please refer to your factory service manual or give us a call at 517-339-3835. www.bakerdrivetrain.com
Пікірлер: 42
@davidchereneimmel88202 жыл бұрын
That's why I like my 06, 88 I still have the chain inspection cover and I don't have to pull the whole primary cover to do such a simple maintenance.
@dennislavigne7889 Жыл бұрын
Those primary gaskets are of very good quality. If you’re careful when removing and installing them you can reuse them many times with no issues
@dtocher5 жыл бұрын
If you are setting the chain at the tight spot, why wouldn't you set it at 5/8"? That way the looser spots would be more than 5/8". It seems to me, that setting it at 7/8" would mean that the loose spots would exceed 7/8". Thanks for the video.
@SDMF50005 жыл бұрын
For the metric people (me) 5/8 - 7/8 is 15.8mm - 22.2mm
@UPanderson15 жыл бұрын
Thank you!
@timojokela4554 Жыл бұрын
Thank`s Baker!
@Beach52892 жыл бұрын
Wouldn't tight spots be created by an elliptical rotation of the comp gear or clutch sprocket , like excessive crank sprocket shaft run out or trans input shaft ?
@paulrevere43264 жыл бұрын
Where are you measuring from?
@allan9584able3 жыл бұрын
what part number i need to get one for my 2019 softail
@dougfresh1341
Wanted the Baker tensioner, but damn, the cost is out of sight.
@wendycross64084 жыл бұрын
Triumph tr25 primary chain
@ih8011 Жыл бұрын
I have a 2012 fxdb installed a comp eliminator and threw everything back on. It came with a boot to go on top of the chain tensioner. The bottom chain is now millimeters away from the gear shifter link is that safe? I know the chain gets slack when torquing or slowing down
@98chicagobears
hey do i have to take off the chain to put the tenchinor or can i still put it on with the chain loose
@alpha-sixfive7433 Жыл бұрын
Aren't they self adjusting?
@randymccalla9995
Crazy ..the only cause for a difference is the e runout on the crank, unless your trans shaft is already bent ( tight spot should be 5/8 so the loose spot is never more than 7/8)...... otherwise noisy primary
@manuelnieves67913 жыл бұрын
The has to be and gear ?
@JoeLyonsHDguy5 жыл бұрын
Who's compensator setup is that?
@blizzardboyy5 жыл бұрын
I installed this and followed the instructions and video. How often do you need to do this?
@lionelscott58395 жыл бұрын
Would it not be a good idea to remove the chain from sprockets and relocate so the power stroke is not always at the same place . This should streach the chain in a new section and over time chain would not have such a mark difference between loose and tight spots .