Yes, that's the tricky bit & it did'nt get shown.. what a shame.😬
@florian-cristibodoi208510 ай бұрын
Salut . Cu cîte ture reglezi la L si la H ????? Dacă se poate imi poți da un reper???? Mulțumesc.
@Christian-ht1eo2 жыл бұрын
I’m halfway through, watched u take that gasket off with ease, I tried it and shredded it
2 жыл бұрын
Super fain. Ai reinviat monstrul de crengi.. Am tăiat 10 ani cu asa ceva de la crengi până la arbori de 80 cm 😈 te salut Ady, toate cele bune. Big 👍
@2strokeenginerepair6182 жыл бұрын
Multumesc John, sunt bune drujbe ptr casa😁…te salut John!🤝
@andygray2073 ай бұрын
I’ve got the same model, followed your strip down and rebuild, starts runs for a few seconds then cuts out any ideas why??.any help would be greatly appreciated,thank you 12:25
@rapukoronaklm2 жыл бұрын
Could You tell me how set L and H screws?
@2strokeenginerepair6182 жыл бұрын
I close them both and then I open each one a turn and then I start the chainsaw and if I have to adjust a little more on each one!
@babylonhobbiesandfpv4862 Жыл бұрын
Is it possible to use the ms181 fuel and oil tanks on my ms180 so i can use the quick release caps on my ms180?
@raeidinnotnineng24719 ай бұрын
No.
@user-fx8bs3kw8c2 жыл бұрын
Ващщее молодцом, только с озвучкой надо было, така же хрень предстоит
@BOTTLEDIGGINGUK2 жыл бұрын
top video
@gabrielilie33552 жыл бұрын
Salut, care este surubul de aer?
@2strokeenginerepair6182 жыл бұрын
Salut este H ptr “aer”
@dujeamizic35882 жыл бұрын
I had change carburetor on ms 250
@ilieghilescu6987 Жыл бұрын
Am la fel drujba Stihl și nu reușesc să te normal la relantiu se tureaza și se oprește o pornire grea și nu știu câte ture trebuie să dau la H,L , LA
@cmarcvids9 ай бұрын
Why is your primer bulb missing? You can start without it?
@ArdGeal5 ай бұрын
There is no primer bulb on the MS181.
@cmarcvids5 ай бұрын
@@ArdGeal oh, ok. so the 181C has the printer bulb.
@Snurre862 жыл бұрын
I adjusted the Low speed screw to the highest rich idle, now i can't turn the idle down enough to stop the chain from spinning.