Adjusting the straps is a lot easier when it isn't on the dog (adjusting straps video helps too). I found opening the side zips made adjustments to the collar and the back straps a lot easier. I used a tape measure to figure out the right length for the back straps, rather than readjusting it several times. This video is not very good at showing how to change the length of the straps, and I was a bit confused about how high up the straps reach (seeing it on a real dog would have helped).
@emilyrowe63429 жыл бұрын
I have trouble keeping the straps tight - has anyone else had this problem?
@Sleepypod9 жыл бұрын
+Emily Rowe Here are Clickit Utility strap adjustment videos - kzbin.info/www/bejne/fXmyoYF4qridmqs and also kzbin.info/www/bejne/oXnammCAlqugaac
@zombie6six7 жыл бұрын
Hi! I'm a parent and I know that the child seat LATCH connectors in the vehicle seat are really only rated for 65 pounds. Doesn't that mean that my 75 pound dog must only use the seatbelt?
@Sleepypod7 жыл бұрын
Hello @babysnooks - Clickit Utility uses a combination of LATCH anchor and seatbelt to restrain the pet. The LATCH anchors in vehicles are required to hold a minimum of 65 pounds. Sleepypod has tested Clickit Utility dog safety harness with crash test dogs weighing 75 pounds at two facilities: at an independent, third party accredited lab, and also at a National Highway Traffic Safety Administration approved crash test facility.
@clares57987 жыл бұрын
The anchor points in my car are not the same as those outlined in the instructions (they're closer to the wheels). Is it possible to lengthen the straps (quite a bit) and use alternative anchor points. I should add, I'm based in Australia with a euoropean car (VW).
@Sleepypod7 жыл бұрын
Hello Clare - Thank you for your interest in the Clickit Utility safety harness. Since your setup is different, the best way for us to determine if Clickit Utility can be used in your car is for you to send us an email with photos: 1) wide shot showing where your anchor points are in relation to the car seat, and 2) closer shot of the anchor points. Please send your question with photos to contact@sleepypod.com
@kimk53328 жыл бұрын
+Sleepypod when the harness is secured properly, is the dog able to lie down at all?
@Sleepypod8 жыл бұрын
+Kim K Yes! A dog can sit, lie down, and shift position but can not walk about when harnessed to the seat using Clickit Utility. See this video featuring the awesome pups from the Ammo the Dachshund blog at kzbin.info/www/bejne/q3Kuc3qLnNdqiK8 - learn more about Clickit Utility at sleepypod.com/clickit
@thetaproducts56518 жыл бұрын
What about a dog in a "booster seat"? My dog dog does better in a booster seat. Is there enough length for this?
@Sleepypod8 жыл бұрын
+Theta Products Clickit Utility is not designed to be used in combination with a booster seat.