Clio mk IV handbrake adjustment - Clio 4 Tce - Clio IV petrol - gas 3 cyl 4 cyl & diesel 4 cyl .

I WAS SCOURING THE INTERNET LOOKING FOR ADVICE ON HOW TO ADJUST THE HANDBRAKE ON CLIO NEW MODELS (MARK IV OR MARK 4 OR MK 4 MIV). THESE WERE SOLD FROM 2013 ONWARDS. Nowhere did anyone show how to adjust the Clio version or mark IV with 3-cylinder triple petrol turbo engines, or 4 cylinder diesels. So, I did this to help anyone else.
The older models it was always underneath the car - 4 10mm nuts to remove an exhaust heat shield then you could adjust the handbrake cable. This is no longer the case.
After getting this one up on ramps to help someone out, I found it seemed even the French maker Renault would have to be beaucoup masochistic to make people remove 16 weird nut things and then 3 panels minimum and so on...
They now adjust from inside the car, the video shows how. ERRATA note: the screws used ARE 'star' head screws, one of the smaller sizes. I thought torx but said star. The two screws ARE star type, NOT torx.
If you found it useful, please thumbs up.
There's nothing inherently bad or offensive about this free how-to help video. If you felt the need to 'thumbs down' then your reason why is eagerly awaited. If you won't explain yourself, it's cowardice and you can p**s off. It's not as if you paid to watch, and you ain't my boss or director. Finally please remember although you seem anonymous to video makers, you are not anonymous either to google or the government. Your anonymity is entirely dependent on it not being in their interest to reveal their ability to ID users.
Thank you kindly.
.
.

[@pauljeffreys7223]

Great video, just adjusted the handbrake. The bit size you need is a T20 to remove the screws and a 13mm ring spanner. Remember to bed the brake shoes in first before adjusting. Raise one wheel off the floor to make sure they are not binding. Thanks for the video.

[@stevensimpson2625]

Thanks goner give it a try 👍

[@LeeJay07701]

Thanks for the help, will be giving this a try shortly 👌

[@denby87]

You really should make sure your wheels aren't binding and of course adjust the mechanism in between brake shoes first,then adjust cable checking for binding as you go.

[@KIRAnovantaquattro]

Thanks, Sir. Your video saved me. Thank you very much for your help!

[@matchless6964]

Very helpfull video ! Thanks !

[@Andy-Robus]

Thank you for the vid. Very good. I'm gonna attempt to do ours soon now then

[@MrRodders4444]

Great video thank you 👍

[@MrCwmgwrach]

The star bit you were using is called a torx bit

[@Dagger2311]

Very helpful, thank you. Yes it's a T15 torx

[@EdoardoDeLarge]

Thanks a lot Jonny!

[@rahulnaik1552]

@@Dagger2311bit size was very helpful,thank u very much.

[@davidlyttle2104]

Thanks much appreciated - 10 minute job 😀

[@innoxolihlatshwayo1764]

I've been getting a hand brake signal whilst driving, so I just wanted to say thank you for thus video. I'll try to fix it👌🇿🇦

[@jameshaveron4197]

Thanks

[@iantomlinson2254]

That should of took 30 seconds

[@JohnWoodcock956]

Will this be the same on a 2008 Clio 1.2