Great video! We have 24 of these drives. I use this video to remind myself of how to set up.
@fabianhernandezramos29523 жыл бұрын
thanks for your time, l learn so much with this type of video
@123jordanford3215 жыл бұрын
Useful video thanks. Happened to have the L18 processor and a Kinetix 350 so this was really ideal!
@chuongnguyen36043 жыл бұрын
I used the Rslogix 5000 but I might find the kinetix 300. I can upgrade the new version now ?
@fethilakhdari10782 жыл бұрын
Good video, too bad the video resolution is so poor, that it takes so much quality away from your good work
@vorapobautomation97602 жыл бұрын
HOW to setting and programming SLAT function with kinetix 5500 ?
@jorgedominguez3355 жыл бұрын
Hello, I followed all your steps and I was able to configure the Kinetix and the servo with no problems. The only problem I'm having is when I unplugged the ethernet cable from the kinetix drive my PLC (L61) goes to Fault Mode, Any suggestions what is happening?
@luissalazaringresosintelig14935 жыл бұрын
Prueba esto: Module Properties (kinetix)... Pestaña Connection... Major Fault On Controller if Connection FAils ( no debe estar seleccionado)
@FC-hr9he4 жыл бұрын
How is this wired? can you show the wiring in a video?