Honda CB350 / CB360 Carburetor Diaphragm Installation

[@hunterlongshore1867]

Thanks Brendan. Just started this part of my rebuild last night and how convenient to have this waiting in my inbox this morning! Will be installing new diaphragms tonight!

[@caroltenge5147]

To get the old bellows and phenolic ring off, rip the bellows away, then just heat the ring on a gas stove. Just a few moments will heat it up, soften it, and it will just pull away and off. East with just a pliars.....No damage to the slide!!!

[@davidrice3056]

Hey Brendan, great video and great that you guys have an option to replace these diaphragms 👍 I have found the rubber in these (JBM) diaphragms to be quite a bit stiffer than the OEM ones, and the carbs don't respond very well to them without some mods (particularly if running pod filters). Seems the stiffer rubber causes the slide to rise much later. I found opening up the two slide lift holes by about 1-1.5mm (3.5mm stock to about 4.5 to 5mm from memory) helps considerably and gets the slides operating much closer to how they do with the stock diaphragms. Of course there are so many variables at play from bike to bike, but info that may be of use if you have any customers running into the same trouble. Cheers👍

[@danielmueller8612]

Hi David, I think I’m having the same problem. I replaced the diaphragms and it runs great at full throttle but sputters like crazy otherwise. Do you think enlarging the slide holes could help? Thanks!!

[@Jqbigrig]

So the parts being cut off aren't replaced?

[@curtn7076]

Thanks for the great video! I just picked up A 69 CB 350 in pretty good shape..I have a lot of questions because the carbs were in a crate.. lol

[@TokyoChopSquad]

I have a 1969 Honda CL 350. Same carb but an earlier model. Can't seem to get my slides out. Any ideas?

[@fippo456]

Thanks, is this also the same for a cb250g?

[@Common-motor]

Yes, but the 250's were either built on a 350 or 360 platform. Need to know what version of the bike you have to order the correct diaphragm.

[@tobaldgo7263]

Kz 305 con carburador keihin

[@alonsodelvalle3838]

Bad way for replace the membrane, you don't need to cut the plastic holder, just use soapy water and install the new one

[@Common-motor]

There's more than one way to skin a cat, they say. We stand behind our recommendations. To each their own though.

[@zenzimen]

hello in what position are the 2 bottom holes of the bushel in relation to the carbu and has the membrane..... parallel to the cylinder or on the side?@@Common-motor

[@shawnitarn]

huh?

[@kemitchell]

Totally bought me an IMZ shirt, too.

[@jasaserzz]

За футболку отдельный лайк))

[@marcelyntema295]

Thanx, its solves the problem for VX800 and replacement.

[@Common-motor]

Glad to help!

[@Froe69]

The 360 is out of stock :(

[@californiamonster8877]

360 @ 9:07