Complete Overview | DIY 6 DOF Racing/Motion Simulator 🏁 | ODrive

[@ZenMotionSim]

Great project. I've been looking at it initially when doing mine.

[@voytikFF]

Great work! Just a question: where did you connect the other end of the green reset cable? I want to have similar stop buttons but couldn't find anywhere how to correctly connect the reset pin on odrive

[@stijnsprojects]

When the E-stop is pressed, the reset pin is connected to GND, in my SIM to GND of the PSU because it's the same as the GND of the ODrive, keep in mind this is a NO contact so it's not a safety stop.

[@wkinne1]

Am I correct in assuming this will work as a flight simulator?

[@stijnsprojects]

Yes that is correct

[@mentalterbelakang]

are u using endstop for calibration sequence in your setup..??

[@stijnsprojects]

Yes, there is a video on my channel about how the odrive is programmed where this is explained.

[@mentalterbelakang]

@@stijnsprojects if i only use 2 odrive (i have plan to build like sfx100), will it work directly with simtools (without flypt mover), because i dont need extra calculation like hexapod configuration

[@stijnsprojects]

It is possible to send the commands from simtools directly to the odrive

[@mentalterbelakang]

@@stijnsprojects ok...thats interesting...

[@mentalterbelakang]

@@stijnsprojects can u share the fw u using..? i want to try that with my setup...