Convert AC 220v to DC 12v Circuit Simulate in Proteus Transformer Capacitor Regulator (7812) Diode I hope you enjoy this video. Copyright KZbin Channel: Thona Tann
Пікірлер: 35
@frknkc4 жыл бұрын
Guys don't forget to add an earth at bottom side of your project. Some of you may get error because of it. Thanks for share
@joselazo19963 жыл бұрын
Thank you so much, I was about to redo everything and all it needed was a bloody ground hahaha.
@alyssiaflonne42955 жыл бұрын
if you guys need 220 in 60 hertz you need to put the amplitude to 311.12 cause the SPICE only records the PEAK rather than the RMHS of the circuit
@refiadityabayuputra27955 жыл бұрын
in the transformer part, why you fill the primary dc resistance with voltage value ?
@sitrakaandriniainarazafinj12594 жыл бұрын
Good question, i noticed it too
@alyssiaflonne42955 жыл бұрын
Also you should always put the Ground in the (-) after the diode but not after the capacitor , also it doesnt really matter if you put 24v in the secondary winding its pretty much the same if you put 1 v since the Transistor adjusts the power Edit: Cause the Proteus Isn't Perfect so we still need to use logic and formulas
@becheikhabdelhadi1883 Жыл бұрын
what better then proteus??
@tkzheng3 жыл бұрын
[SPICE] TRAN: Timestep too small; timestep = 5.55112e-017: trouble with node #00002. why does happen this?
@alfayhasci66425 жыл бұрын
wonderful video, Also .. we can use bridge rectifier directly ..
@RafiRizqullah-vq1mz Жыл бұрын
makasih ilmu bermanfat infomaszeh\
@juttsahab99682 жыл бұрын
excuse me.... what is tha purpose of 7812...kindly tell me ..
@Brief-Biography2 жыл бұрын
Regulate DC Voltage to DC 12V
@juttsahab99682 жыл бұрын
@@Brief-Biography thank u....❤️❤️❤️
@ameerhamza70845 жыл бұрын
how the calculation is done for capacitors?????
@med64026 жыл бұрын
in the transformer you changed the resistance and thats wrong you need to change the copling factor to get the desired output voltage
@Brief-Biography6 жыл бұрын
Thanks
@haneefsolangi92925 жыл бұрын
#med can u tell me how??
@ahmedelkhateeb49065 жыл бұрын
@@haneefsolangi9292 you can change the inductance of the secondary coil from the equation (Np/Ns)^2= Cf * (Lp/Ls) where - Cf is the coupling factor and it is a constant and assume it =1. -Lp is the primary inductance -Ls is the secondary inductance