Corolla Wheel Bearing Replacement Part I

[@TheBlazen001]

its easy witout press too.u just take small socket with extension on knock out the hub.take off that seal from behind plus its there snap o-ring.now u have a one piece iner race on your hub.just cut in half and smack with hamer and chisel,will brake easy,or cut and remuve that wit air hamer.now clean your bearing of inner race and balls,u can do it with screwdriver.now u have just that outer race in your knuckle.take big shisel and big hammer and knock it out!!instaling this new bearing

[@dantheairboatman1234]

I just finished this job on both sides your vids were very helpful and precise, if I were to make one point you needed to include how far to drive the grease seals in, all the way to the race or even with the edge of the hub. Thanks again.

[@RoberTastic]

@TheBlazen001 @MrWildECoyote1 I just did my mom's corolla.. the hub hammers out easily with a sledge and a socket.. you don't have to wack it.. just choke up and give solid taps so to speak.. also got the outer race started with a sledge, after it seemed to be giving me problems with the press.. finished the job with the press.. bearings were in the freezer and they pressed in very easily... had more problems iwth the grease than anything.. great vid though

[@TheBlazen001]

just put into the knuckle put there some oil,on top new bearing put old outer race and knock in !!!that is how we do it in europe!!

[@ASEmastermechanic]

It is for a 2000 Corolla.

[@Qbasic8]

Great except here in Ohio the snaprings on like Corollas, etc... never want to come out. sandblasting, some pb, and some swearing and it eventually comes apart.

[@blackops2presentsdown2ryse53]

i need help ! is it worth getting both sides of the wheel barrings replace for 280 at the mechanic ??

[@lemus92405]

my Buddy Paid 70 to get the bearings replaced on one side so 280 seems a bit steep

[@ASEmastermechanic]

Can't you just buy the wheel bearing hub assembly as a unit for people that work at home? Most home mechanics do not have access to all of those shop tools.

[@toma1383]

I am replacing bearing on 2010 Corolla. I cannot find parts for inner and outer seals and the dust shield, not even on Toyota websites. Any idea where to find the right parts, Toyota has been no help. They were damaged when I removed bearing and needed to be replaced anyway but now I cannot find replacement. Any help would be appreciated greatly.

[@Iwillbedurnd]

So what do you use to lubricate the bearing? Grease or oil. Do you pack it?

[@TheBlazen001]

just put into the knuckle put there some oil,on top new bearing put old outer race and knock in !!!that is how we do it in europe!!