Remember when my relative bought a nearly new 3095 datatronic, it was the big modern tractor of the day and it felt enormous!! 3rd and 4th back to front took some getting used to!! Loved the sound of the Perkins 6 cyl
@sianwarwick63325 күн бұрын
Satisfying work. Looking forward to seeing more
@bobuncle870427 күн бұрын
Farmer P mentioned he saw you at Cereals today, so here I am. Nice video, new subscriber
@calumanderson5617Ай бұрын
YIKESSSS ..... 😮 I have never seen that happen on a starter motor before, I wonder what on earth caused that !?!?, thank you for the video Dan. 🙂👍
@colmcultra1870Ай бұрын
Good video have one myself great old tractor
@casto-Ай бұрын
When 1 job turns to a dozen 😆🤦♂. Kinda impressive that the ring gear didn’t chip any teeth or the fact the broken bit didn’t jam everything up!
@dougpeterson5257Ай бұрын
Turned out good, best wishes when you attack the electrical issues.
@graemebowyer4901Ай бұрын
I put a new starter on my 3070 about 5 years ago, , but I still get the odd click. The revised wiring at the front end has got me thinking though. Very interesting as usual.
@garethparr9482Ай бұрын
Nice neat job as always Dan 👍
@philipedwards8492Ай бұрын
Good Video Dan. Always something to be learnt, Thank You
@bobpaterson1845Ай бұрын
The gods were indeed on your side when that solenoid wouldn't come off that could have been a real disaster 🙄😐 good video 👍
@robertallen3441Ай бұрын
The bellhousing will be full of metallic dust from the broken starter motor housing and from the clutch plate. I think I would have cleaned it out properly before fitting the new starter. As you probably know the small yellow and red wires at the battery pos terminal supply power to the etcu behind the RH cab step. Most electronic problems on 3000 series are caused by poor wiring giving low voltage readings. Alternator also needs to be producing 13v at least to power ELC (rear linkage). Always test electrics with a headlight bulb and two wires, a multimeter is not good enough.
@RickwardfulАй бұрын
99% of all 3000 series electrical problems can all be traced back to where the the earth cable from the Battery is connected to the chassis at the from and corrosion of the positive terminals preventing full current. Not helped by usually having 2 batteries to deal with! The red and yellow wires attached to the positive are very important to make the hydraulics and PTO work properly.
@CowfarmerDan9 күн бұрын
I repositioned the earth cable to the clutch housing last year to avoid that problem.
@seamuscusack7937Ай бұрын
Another great video Dan
@williamharris4426Ай бұрын
Could have been a disaster, if that bit of casting got between the ring gear and bell housing.
@nickwilkins3616Ай бұрын
Was that a David Brown parked up by your Massey, would that be one of yours? By the time you finish the Massey that’ll be one nice tractor.
@wulliewhyte544Ай бұрын
Great video again Dan
@craigdoig9486Ай бұрын
16:19 great job done
@TheStevegraingerАй бұрын
Great video Dan. Why do manufacturers put a drain for the engine block behind the starter must be a better place.
@CowfarmerDanАй бұрын
There's a drain on each side of the block, I just wanted to flush that one while I had access.
@charleshart6992Ай бұрын
Great video Dan
@bencarter2334Ай бұрын
David brown behind the Massey
@roba4297Ай бұрын
Good job you didn't have a half-moon spanner to remove the solenoid nut !!!
@stephenheyes4324Ай бұрын
Luck was with you there a potential disaster averted good job
@pauljones2633Ай бұрын
That was a very lucky find! What’s the story with the Davy Brown in the hedge?
@CowfarmerDan9 күн бұрын
It's one of my brothers projects.
@multipower617Ай бұрын
Very nice job on the terminals On the subject of swapping batteries between classics that don't do much, are there any decent quick attach terminals?
@CowfarmerDan9 күн бұрын
Not sure, I've never considered fitting them!
@multipower6179 күн бұрын
@@CowfarmerDan I've got a habbit of putting on a battery just to move something quickly and not tightening the terminals and it ends up staying that way ,but inivetibly you go on a tractor run and it wont start