Coyote Swap How To: Clutch Job On Foxbody Coyote With Mach1 (3650) Transmission

Sorry for the vid cut short. First time using the app and I didn’t realize how long each clip was.
The mach1 transmission is a cheaper alternative for a coyote swap but one thing to consider is the bell housing does not separate from the trans so you WILL have to remove headers to get to clutch. Other than that it is like swapping a clutch on a 96+ mustang
Again sorry for the vid i will do better next time

[@RRRx4690]

Your Fox body game is on point my bother...... Keep up the great work....

[@3pedalfox]

Bro! I just went through this dilema. I had a QuickTime bellhousing, TRASH!!! Went with a Ford bellhousing and TKO. All I have to do is loosen a header and it all comes out. Good shit by the way 👍

[@whitefoxcoupe2024]

Great video. Keep them coming.

[@pacman5955]

Hell ya!!! take this KZbin game serious love the intro

[@dustinguriel620]

I know the struggle brother! Have a supercharged 97 cobra with bbk longtubes. Put a brand new rebuild in and guess what.. the rear main leaked immediately! Can’t wait to ditch all of it and do the coyote + t-56 swap to make my life better lol!

[@smallenginerepair3379]

That intro was bad ass, i think u will get it out without dropen it all the way

[@Foxbodygarage_satx]

🔥🔥🔥 good shit mayne!

[@panthor2003]

Looks like you could get it out, maybe loosen the header bolts to get that extra space....

[@Alanc419]

Great video! So what would you say? Is the T56 cost worth the money, so that clutch changes are easier? Seems like an S load of work to yank a motor, so the clutch can be replaced..

[@damariocarson3793]

OH SHIT DOPE INTRO

[@PVOSQUAD365]

Paused at 5:07 and I say yes you’ll be able to get it out. If anyone can do it bro it’s you 100% #pvoisontherise

[@henrygomez5820]

Hey bro does transmission tunnel shifter hole match with the 3650 shifter or needs to be modified??

[@pcpalan]

If the car you are putting it into originally started its life as an automatic, yes you will have to cut the tunnel.Not too much though just an inch or 2. If it started it’s life as a 5 speed car, I don’t think it’s necessary. It’s been a while since I swapped original manual transmission car

[@eugeneowens82]

Quick question I have a 85 carb car and a 97 explorer donor car to make efi what would I need to do...or can I just use a mustang 86-93 efi system...if so what would be needed as well...

[@Jdslidez_]

What clutch do you recommend I have this tranny set up and haven't bought a clutch yet!!

[@bryanshelley6727]

Did you end up buying a clutch yet? Will a 3650 clutch bolt to the Coyote flywheel??

[@Jdslidez_]

@bryanshelley6727 I haven't i have the tranmission and rhe engine but my car needs a lot of work been buying little here and there but random stuff I know the 3650 bolts onto the engine fine same pattern

[@MariaPerez-wd5lm]

Hey Midnight