HOW-TO REMOVE FUEL TANK - HQV 901 NORDEN - ROTTWEILER PERFORMANCE

[@erichameister7000]

this was a GREAT video. thanks for the time and expert analysis.

[@RottweilerPerformance]

Glad it helped!! Thanks for watching.

[@AlekseiFenev]

Thank you so much for the video!!!!!

[@RottweilerPerformance]

Glad it helped!!

[@gordmounce6112]

That was an awesome instructional video! Very clear, with great camera work. Thanks!

[@RottweilerPerformance]

Glad it was helpful!!

[@jerrydog8671]

I don't even own a Norden, but Chris does the best instructional videos on the planet. Huge help with my 990.

[@RottweilerPerformance]

Thank you Joey Dog! We are trying to put out one per week, which is a lot of work, but we are working on simpler ways of creating these without braking the bank or mind so we can bang them out and supply our customers with some hopefully good content. Thank you for noticing.

[@MotoPumps]

Another great video. Thank you. Thanks to KTM / Husky for standardizing the hardware. Every other manufacturer needs to take note! This matters!

[@nordenamerica]

Perfect timing! I needed this video to remove the tank and track down a coolant leak. Probably a loose hose clamp. Also one of my welded on nuts to a tank bolt came loose so now I can fix that too. This video is so well made and easy to follow. Thanks!

[@RottweilerPerformance]

Love that! All we hope to do is help with these videos and I’m glad it did. We put one out every week and it all just depends on what we have going on and what we can film.

[@nordenamerica]

These instructions worked perfectly!! Tank is off the bike. Thanks. Not mentioned but I did clip one small cable tie on lower left side of the tank holding the fuel lines and wires together.

[@ironinfidel7792]

love your style brother! Very entertaining.

[@RottweilerPerformance]

Glad you enjoyed it! We try!

[@SPENJERE]

Great video, very informative. Just picked up a Norden this week I'm sure I'll be watchin many more of your how to videos.

[@RottweilerPerformance]

Right on! Congrats on the new bike.

[@garethjones7651]

Could you do a video on how to tighten all the hose clips for the coolant. Cause apparently the one behind the rad is tight ti get to but can all be done without striping the bike down.

[@RottweilerPerformance]

We’ll put that on the list!

[@bigmikes901adventures]

Thank you so much that was exactly what I needed so I can remove the canister and install a Denali Soundbomb Split!!

[@RottweilerPerformance]

Awesome! Glad it helped!

[@advmike]

Thanks! I’ve got a side stand bypass dongle to install. Yay. Plenty of bike wrenching time for this one. 🤦‍♂️

[@philiplaurell1163]

Thank you so much. Very helpful (Got my wife and dog back. She sold the pickup truck, though)

[@RottweilerPerformance]

Ha!! Love it!

[@TorkildNohre]

Thank you! Solved my problem.

[@RottweilerPerformance]

Awesome! Glad this was helpful.

[@NMdesertracer]

Atleast the radiator reservoir fill cap makes sense on the Norden! On my 790 its like what were they thinking!!! 790 tanks is way more quick to take off tho..

[@nicholaschai4458]

Love the sense of humour 🤣😂🤣😂

[@RottweilerPerformance]

We try to have some fun with it lol. Thanks for the comment about it!

[@nicholaschai4458]

@@RottweilerPerformance that’s what makes you guys stand out.💪🏻👍🏻🤘🏻

[@jannelindroth]

Is there any differences to the 890 Adventure? Can’t find a specific video for that one

[@Klaus53123]

Excellent video many thanks. I have a brandnew 901 expedition and I want to run a USB cable from the handlebar to the battery. Will I be able to run the cable in a secure position by just removing the bodywork or do I have to dismantle the fuel tank to find some space? Best regards Klaus

[@210078]

Awesome!! I wonder if their will be an after market bigger tank for this. Think I'm going to wait a bit to see what is going to happen with this bike...

[@geoffmoore3005]

Have to agree with comments about Chris doing great videos. Chris, what is the plan with the new 1290... this is something I am sweating on here in AUS. Please give us some idea what the plans are, so that the rest of us can plan our purchases from you.

[@magnusb6311]

Liked and subscribed. Is the Norden Expedition about the same?

[@RottweilerPerformance]

Pretty much the exact same internally with some BNG! (Bold New Graphics...) Thanks for the like/subscribe!

[@magnusb6311]

@@RottweilerPerformance That is close enough.

[@stivbrala1714]

Great video 👍🏻. Does the KTM 890 Magura Hymec hydraulic clutch system fits the Norden 901???

[@pellegrinoinmoto]

great job man!

[@RottweilerPerformance]

Thanks! It's only a great job if this helps people so hopefully it helped you!

[@westwater73]

Great work but what a palaver I'll never complain about the one 10mm bolt and four 8mm rad bolts and my fuel line again ohh and unlock my seat 😀

[@alfredodipalma7161]

Great video. I am trying to decide between this bike and the Africa Twin. I think this bike is great except I keep seeing comments on quality issues specially on coolant leaking. It would be great to see a video on to check to ensure that if someone has this bike what should they focus on.

[@gordmounce6112]

Not sure if it's still relevant for you, but the coolant issue with 890s and 901s was related to some loose clamps caused (I believe) by some settling in the hoses after they've been run for a while. The solution; tighten the clamps. You only need to do this once. Loving my Expedition so far btw. Hopefully you're on a new 901 or AT by this point! Both great choices.

[@MikeSuch13]

On that fuel line that connects to the throttle body, is there any wiggle in that hose after it’s locked in

[@RottweilerPerformance]

Yes, the connection will be sealed just fine but can 'float' a little in and out. Not to worry if this is in fact what you are talking about.

[@jonelvidge9191]

Hi, I’m looking at getting the new Husky Norden 901- I took one out and found the gear change selecter lever was set very high.i had to move my foot off the peg to snick a new gear rather than rotating my ankle up/down. With it fitted with a QS how to you lower the selecter lever to personalise it to yourself. A lot of bikes gear levers are clamped around a spline into the gearbox - I couldn’t ascertain if this is the same on the 901

[@RottweilerPerformance]

Jon, there are a couple of ways. The spline method is still possible on that bike but because it’s not directly shifted (like a dirt bike) it’s in a different spot up on the lever on the engine. You can remove that small 6mm bolt and move the lever one way or another. You can even go to GP shift on the Duke in seconds by reversing that same lever. In your case, you can start there and use the splines for larger height changes, and then use the tie rod style adjustment on the push/pull rod for finer adjustments until it is perfect for you. That is the one big advantage of linkage style shifting, you have a lot of control over adjustments and ratios.

[@jonelvidge9191]

@@RottweilerPerformance cheers, it wasn’t that obvious with the footrest hanger shrouding it when I cast my eye over the demo bike -

[@howlinhog]

Thanks for the heads up on playing country music backwards. I'll be sure to avoid that at all costs. P.S. Sorry Duke old buddy, I loved you but it's just not worth the risk.

[@Captndarty]

Wow and I thought my 1190 was bad…. At least there’s really no reason to remove this one.

[@RottweilerPerformance]

That really depends on your needs. I would say this one is much easier than a 1050-1290 once you get to know it, but neither are difficult if you know what to look for.

[@elysium81]

Cool video….one more subscriber😊

[@RottweilerPerformance]

Can't not love this!!

[@Angela-bi9rr]

Bravo!!!saluti dall italia potresti fare un video che dice come isolare dal gelo le parti elettriche o liquidi per chi va in Russia o Alaska per avventura!🙃😉

[@dusdroadadventures7978]

Haha I resemble the rubber grommet dive. Haha

[@RottweilerPerformance]

That’s been a thing since the 950 Adventure in 2004. People have been chasing (or losing them) for years. Thought it would be funny to show people we feel their pain LOL.

[@dusdroadadventures7978]

@@RottweilerPerformance Mine ended up dead center under the rear tire. Bike was maybe an inch off the ground with the bike jack. I looked and looked. Haha thinking where in the heck. 20 minutes later. Haha crazy

[@Ariautoace]

Hahahahaha "not completely screwed".

[@frankengel5562]

Nonononono🤣

[@RottweilerPerformance]

1.85 million KTM owners have uttered that same phrase when dropping those rubber parts! 🤣